22 · Diagnostics

Eol configuration changed error

Fault diagnosisEol configuration changed error

EOL CONFIGURATION CHANGED ERROR

The diagnostic equipment signals the error: C1103 - EOL configuration changed

This error is signalled if the ABS-VDC control unit receives a vehicle configuration from the Body Computer that is not valid

1	PROXI ALIGNMENT BY BODY COMPUTER	All OK	Problems met	Operation
		Results of the tests
	Connect the diagnostic equipment, turn the ignition key ON and, in the active diagnosis ambient at the Body Computer control unit, request the PROXI alignment. The ABS control unit should not appear amongst the control units for which the latter is required	Continue to Step 4	The ABS control unit requires PROXI alignment	Carry out the PROXI alignment for the ABS control unit
2	CONTROL UNIT COMPATIBILITY CHECK	All OK	Problems met	Operation
	Check that the design number of the control unit is compatible with the spares number for the Model - Version-Series in question	Continue to Step 1	The design number is not compatible	Continue to Step 3
3	RECALL CAMPAIGN CHECK	All OK	Problems met	Operation
	Check that there is no recall campaign in progress which involves changing the ABS control unit	Continue to Step 4	There are recall campaigns in progress	Replace the ABS electro-hydraulic control unit with the new one, compatible with the recall campaign Op. 3340A12
4	CHECK ON CORRECT OPERATION	All OK	Problems met	Operation
	Turn the key to the OFF position and then the ON position to ensure that the control unit checks whether the PROXI alignment has been successful. Check that the fault is no longer present	End of diagnosis	The fault persists	Continue to Step 2

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.