Workshop Manuals Factory service & repair Fiat
01 General information02 Specifications03 Manufacturing data and tolerances04 Tightening torques05 Fluids and lubricants06 Maintenance07 Diagnostic checks08 Engine09 Clutch10 Gearbox and differential11 Axles and driveshafts12 Brakes13 Steering14 Suspension and wheels15 Heating, air conditioning and auxiliary units16 Electrical equipment17 Body fittings18 Body panels and frame19 Wiring diagrams and electrical functions20 Wiring harnesses21 Connectors and pin-outs22 Fault diagnosis23 Special tools
Fiat Stilo Factory Service Manual (2001-2007)22 · Fault diagnosis
22 · Diagnostics

Speed sensor error electric error

Make
Fiat
Model
Stilo Factory Service Manual
Year
2001–2007
Section
Examiner › Speed sensor error electric error
Fault diagnosisSpeed sensor error electric error

SPEED SENSOR ERROR ELECTRIC ERROR

The diagnostic equipment signals one or more of the following errors: C1200 ADX speed sensor, electrical error, C1205 ASX speed sensor, electrical error, C1210 PDX speed sensor, electrical error and/or C1215 PSX speed sensor, electrical error

This error is signalled if the control unit receives an open circuit or short circuit (at the positive or earth) at a sensor or wiring. This fault can also be detected if the control unit connector is damaged.

Results of the tests
1SENSOR CHECKAll OKProblems metOperation
Visually inspect the state of the sensors affected by the error (front and/or rear, right and/or left) and the wiring.Continue to Step 2Left front sensor faulty

Replace sensor Op. 3340A26.

Continue to Step 3

Right front sensor faulty

Replace sensor Op. 3340A28.

Continue to Step 3

Left rear sensor faulty

Replace sensor Op. 3340A35.

Continue to Step 3

Right rear sensor faulty

Replace sensor Op. 3340A37.

Continue to Step 3

Wiring faulty

Restore the correct connections See E7020 ABS.

Continue to Step 3

2CONTROL UNIT CONNECTOR CHECKAll OKProblems metOperation

Check that the control unit connector is not faulty at the pins (on both the wiring and control unit sides) by carrying out a visual inspection.

In particular, check that:

  • They are not oxidized
  • They are not distorted or broken
Continue to Step 3Wiring side connector faultyReplace the wiring Op. 5505C28
Control unit side connector faultyReplace the electronic control unit Op. 3340A12
3CHECK ON CORRECT OPERATIONAll OKProblems metOperation

Delete the errors using the diagnostic equipment.

Turn the ignition OFF and then ON to make the control unit check whether there are errors present

Check that the fault is no longer present

End of diagnosisThe fault persistsContinue to Step 2

Parts & tools for this job For 2001 Fiat Stilo

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.