1036 timing system – exhaust shaft
- Make
- Fiat
- Model
- Stilo Factory Service Manual
- Year
- 2001–2007
- Section
- 10 engine › 1036 timing system – exhaust shaft
‹ Prev 1036 timing system – cylinder head intake and exhaust shaftsNext › 1036 timing system – hydraulic tappet
Manufacturing data and tolerances1036 timing system – exhaust shaft
1036 TIMING SYSTEM – EXHAUST SHAFT
| Exhaust shaft nominal cam lift (mm) | Validity | 
| ||
|---|---|---|---|---|
| 9.0 | 2.4 20v | |||
| Nominal cam lift (mm) | Validity | |||
| 8.5 | 1.8 16v | |||
| Camshaft cam height (mm) | Validity |
| ||
|---|---|---|---|---|
| Exhaust | Inlet | |||
| 8 | 8.5 | 1.6 16v | ||
| Diameter of 1st˚ camshaft bearing, timing side (mm) | Validity | 
| ||
| 29.944 - 29.960 | 1.6 16v | |||
| Diameter of 2nd˚ camshaft bearing, timing side (mm) | Validity | |||
| 52.400 - 52.415 | 1.6 16v | |||
| Diameter of 3rd˚ camshaft bearing, timing side (mm) | Validity | |||
| 52.800 - 52.815 | 1.6 16v | |||
| Diameter of 4th˚ camshaft bearing, timing side (mm) | Validity | |||
| 53.200 - 53.215 | 1.6 16v | |||
| Diameter of 5th˚ camshaft bearing, timing side (mm) | Validity | |||
| 53.600 - 53.615 | 1.6 16v | |||
| Cam lift (mm) | Validity |
| ||
|---|---|---|---|---|
| 7.5 | 1.2 16v 1.4 16v | |||
| Check load (daN) | Validity | 
| ||
| 11.73 - 12.51 | 1.4 16v | |||
| Crankshaft end float (mm) | Validity | 
| ||
| 0.15 - 0.34 | 1.2 16v 1.4 16v | |||
| Journal diameter (mm) | Validity |
| ||
| ø 1 | ø 2 | ø 3 | ||
| 35.000 ÷ 35.015 | 48.000 ÷ 48.015 | 49.000 ÷ 49.015 | 1.2 16v | |
‹ Prev 1036 timing system – cylinder head intake and exhaust shaftsNext › 1036 timing system – hydraulic tappet
Parts & tools for this job For 2001 Fiat Stilo
- PARTExhaust gasketSearch: Fiat Stilo 2001 exhaust gasket
- TOOLPenetrating oilSearch: penetrating oil
- TOOLOBD2 scannerSearch: OBD2 scanner
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.