Workshop Manuals Factory service & repair Lancia
Lancia Thesis Factory Service Manual (2002-2009)22 · Fault diagnosis
22 · Diagnostics

Clock not working

Make
Lancia
Model
Thesis Factory Service Manual
Year
2002–2009
Section
On-board instruments › Clock not working
Fault diagnosisClock not working

CLOCK NOT WORKING

With the ignition on, the display does not show the time or does not show the correct time;

the information is supplied by the "connect" and is made available to the "instrument panel node" via the B-CAN.

STEPOPERATIONS TO BE CARRIED OUTTEST RESULTS
1CHECK USING DIAGNOSTIC EQUIPMENTALL OKPROBLEMS ENCOUNTEREDACTION

Connect the Examiner diagnostic equipment to the diagnostic connector and check the following at the CAN:

  • no control unit not activated;
  • that there are no faulty control units;
  • no control unit with faulty CAN line;
Move on to StepPresence of faultsContinue following the instructions for the diagnostic equipment
2CHECK USING DIAGNOSTIC EQUIPMENTALL OKPROBLEMS ENCOUNTEREDACTION

Keeping the Examiner diagnostic equipment connected to the diagnostic connector, check the following at the instrument panel node:in active diagnosis ambient

  • the operation of the reconfigurable matrix.
Move on to StepDisplay not working

Replace instrument panel

See in Op. 5560B11 ANALOGUE CONTROL PANEL - R.R. or Replace

3CHECK ON CORRECT OPERATIONALL OKPROBLEMS ENCOUNTEREDACTION
Check that the fault is no longer present

Parts & tools for this job For 2002 Lancia Thesis

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.