Display of suspension failure message at matrix
- Make
- Lancia
- Model
- Thesis Factory Service Manual
- Year
- 2002–2009
- Section
- On-board instruments › Display of suspension failure message at matrix
‹ Prev Power assisted steering failure display at the matrixNext › Display of fault codes on matrix - engine starts
Fault diagnosisDisplay of suspension failure message at matrix
DISPLAY OF SUSPENSION FAILURE MESSAGE AT MATRIX
The suspension fault display is activated by the S.C.S. suspension control unit by means of a direct command to the Instrument Panel Node.
| STEP | OPERATIONS TO BE CARRIED OUT | TEST RESULTS | ||
|---|---|---|---|---|
| 1 | CHECK USING DIAGNOSTIC EQUIPMENT | ALL OK | PROBLEMS ENCOUNTERED | ACTION |
Connect the Examiner diagnostic equipment to the diagnostic connector and check the following at the S.C.S. control unit:in errors ambient
| Move on to Step | 1. system/component fault | 1. continue following the instructions for the diagnostic equipment | |
| 2. warning light operation faulty | Move on to Step | |||
| 2 | ELECTRICAL SYSTEM CHECK | ALL OK | PROBLEMS ENCOUNTERED | ACTION |
| Check the continuity/insulation between the S.C.S. control unit and the Instrument Panel Node | Move on to Step | Electrical connection defective | Restore the electrical connection (Wiring Diagram ) E4010 INSTRUMENT PANEL | |
| 3 | CHECK ON CORRECT OPERATION | ALL OK | PROBLEMS ENCOUNTERED | ACTION |
| Check that the fault is no longer present | fault persists | Replace instrument panel | ||
‹ Prev Power assisted steering failure display at the matrixNext › Display of fault codes on matrix - engine starts
Parts & tools for this job For 2002 Lancia Thesis
- TOOLCoil spring compressorSearch: coil spring compressor
- TOOLBall joint separatorSearch: ball joint separator
- PARTShock absorbersSearch: Lancia Thesis 2002 shock absorbers
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.