Workshop Manuals Factory service & repair Lancia
01 General information02 Specifications03 Manufacturing data and tolerances04 Tightening torques05 Fluids and lubricants06 Maintenance07 Diagnostic checks08 Engine09 Clutch10 Gearbox and differential11 Axles and driveshafts12 Brakes13 Steering14 Suspension and wheels15 Heating, air conditioning and auxiliary units16 Electrical equipment17 Body fittings18 Body panels and frame19 Wiring diagrams and electrical functions20 Wiring harnesses21 Connectors and pin-outs22 Fault diagnosis23 Service news bulletins24 Special tools
Lancia Thesis Factory Service Manual (2002-2009)22 · Fault diagnosis
22 · Diagnostics

Trip meter does not zero

Make
Lancia
Model
Thesis Factory Service Manual
Year
2002–2009
Section
On-board instruments › Trip meter does not zero
Fault diagnosisTrip meter does not zero

TRIP METER DOES NOT ZERO

With the ignition on the trip meter is not zeroed when the 0 km button is pressed;

the km zeroing button is directly connected to the instrument panel node and has two functions:

  • the km zeroing button is directly connected to the instrument panel node and has two functions:
  • 1. "km zeroing" function when pressed for a long time (more than 3 secs)
  • 2. "escape" function when pressed for a short time (less than 3 secs)
STEPOPERATIONS TO BE CARRIED OUTTEST RESULTS
0PRELIMINARY CHECKALL OKPROBLEMS ENCOUNTEREDACTION

Check that with thei ignition key on:

  • with the door open (door open display on matrix) when the button is pressed for less than 3 seconds the "escape" function is activated
  • with the lights on the ideogram on the button is lit up
Move on to Step1. the function is not activated and the LED is not lit upMove on to Step
2. the escape function is not activated and the LED is lit upMove on to Step
1KM ZEROING BUTTON CHECKALL OKPROBLEMS ENCOUNTEREDACTION

Remove the km zeroing button and check that it is working properly

(Wiring Diagram ) E4010 INSTRUMENT PANEL

Move on to StepZeroing button defective

Replace the km zeroing button

See in Op. 5560B15 Milometer zeroing CONTROL - R.R.

2CHECK ELECTRICAL CIRCUITALL OKPROBLEMS ENCOUNTEREDACTION

Remove the instrument panel [PR. 5560B11] and check:

  • the connection between the km zeroing button and the instrument panel
  • the connection between the km zeroing button and the instrument panel
Move on to StepConnections and/or earth faulty

Restore the connections and, if necessary, replace the wiring

(Wiring Diagram ) E4010 INSTRUMENT PANEL

3CHECK ON CORRECT OPERATIONALL OKPROBLEMS ENCOUNTEREDACTION
Check that the fault is no longer presentFault persists

Replace instrument panel

See in Op. 5560B11 ANALOGUE CONTROL PANEL - R.R. or Replace

Parts & tools for this job For 2002 Lancia Thesis

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.