Workshop Manuals Factory service & repair Lancia
01 General information02 Specifications03 Manufacturing data and tolerances04 Tightening torques05 Fluids and lubricants06 Maintenance07 Diagnostic checks08 Engine09 Clutch10 Gearbox and differential11 Axles and driveshafts12 Brakes13 Steering14 Suspension and wheels15 Heating, air conditioning and auxiliary units16 Electrical equipment17 Body fittings18 Body panels and frame19 Wiring diagrams and electrical functions20 Wiring harnesses21 Connectors and pin-outs22 Fault diagnosis23 Service news bulletins24 Special tools
Lancia Thesis Factory Service Manual (2002-2009)22 · Fault diagnosis
22 · Diagnostics

Fuel consumption gauge not working

Make
Lancia
Model
Thesis Factory Service Manual
Year
2002–2009
Section
On-board instruments › Fuel consumption gauge not working
Fault diagnosisFuel consumption gauge not working

FUEL CONSUMPTION GAUGE NOT WORKING

2.0 TB, 2.4 20V, 3.0 V6, 2.4 JTD 10V

the instantaneous fuel consumption signal is supplied by the "engine control node" via the C-CAN network; the "computer body node" sends it on the B-CAN network via the gateway and then on to the "instrument panel node".

STEPOPERATIONS TO BE CARRIED OUTTEST RESULTS
0PRELIMINARY CHECKALL OKPROBLEMS ENCOUNTEREDACTION
Check that the instantaneous fuel consumption value appears on CONNECTMove on to StepNo value appears on CONNECTMove on to Step
1CHECK USING DIAGNOSTIC EQUIPMENTALL OKPROBLEMS ENCOUNTEREDACTION

Connect the Examiner diagnostic equipment to the diagnostic connector check the following at the instrument panel node:In active diagnosis environment

  • indicator operation
Move on to StepThe pointer does not move

Replace instrument panel

See in Op. 5560B11 ANALOGUE CONTROL PANEL - R.R. or Replace

2CHECK USING DIAGNOSTIC EQUIPMENTALL OKPROBLEMS ENCOUNTEREDACTION

Connect the Examiner diagnostic equipment to the diagnostic connector and check the following at the CAN:

  • no control unit not activated;
  • that there are no faulty control units;
  • no control unit with faulty CAN line;
Move on to StepPresence of faultsContinue following the instructions for the diagnostic equpiment
3CHECK ON CORRECT OPERATIONALL OKPROBLEMS ENCOUNTEREDACTION
2.0 TB,2.4 20 V,3.0 V6Check that the fault is no longer presentFault persists

Replace engine control unit

See in Op. 1056B82 Injection/ignition system CONTROL UNIT (one) - R.R.

3CHECK ON CORRECT OPERATIONALL OKPROBLEMS ENCOUNTEREDACTION
2.4 JTD 10VCheck that the fault is no longer presentFault persists

Replace engine control unit

See in Op. 1060G80 Diesel electronic injection system CONTROL UNIT - R.R.

Parts & tools for this job For 2002 Lancia Thesis

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.