NOTE: Position earth lead to mounting fixing.

72. Disconnect the following multiplugs/connectors 97. Position transmission assembly beneath vehicle. from transfer box: 98. Clean engine to gearbox mating faces. Speed transducer 99. Clean engine to gearbox dowels and dowel Parking solenoid Neutral detection switch 100. With assistance, raise transmission on jack and Differential lock Temperature sensor switch 101. Fit 2 lower bell housing to engine bolts and
73. Remove 2 cable ties securing harness to transfer box. 102. With assistance, raise engine and transmission
74. Position jack to support engine sump.

CAUTION: Use a block of wood or hard rubber pad to protect sump.

75. Remove 2 remaining bell housing to engine bolts. 103. Remove engine jack from beneath vehicle.
76. With assistance, lower transmission and engine 104. Secure harness to transfer box with cable ties. jacks until hi-low selector lever is clear of 105. Connect multiplugs/connectors to transfer box. transmission tunnel aperture. 106. Raise transmission and align to mounting
77. Separate transmission from engine and lower on jack. 107. Fit transfer box RH flexible mounting heat shield
78. Remove transmission assembly from beneath ramp. 108. Align RH mounting to chassis and secure with
79. Position lifting eyes to transmission and secure with bolts. 109. Fit and tighten nut securing RH mounting.
80. Fit lifting chains to eyes and connect. 110. Align LH mounting to chassis and secure with
81. Position lifting hoist and connect lifting chains.
82. Raise hoist until chains are taught.
83. Remove bolts securing cradle to transfer box.
84. Raise transmission from cradle.
85. Refit transfer box rear cover plate bolts.
86. Lower transmission assembly onto work bench. 111. Position heat shield to LH mounting bracket and
87. Disconnect lifting chains from eyes.
88. Remove bolts securing eyes to transmission and 112. Remove bolts securing transmission cradle to remove eyes.
113. Lower transmission jack and remove from

Refit

114. Fit and tighten transfer box rear cover bolts.
89. Position lifting eyes to transmission and secure with bolts.
90. Connect lifting chains to eyes.
91. Raise transmission assembly from bench and position above transmission cradle. 115. Position earth lead to RH side of transfer box
92. Remove 2 transfer box rear cover plate bolts.
93. Lower transmission onto cradle, align to transfer 116. Feed hand brake outer cable through body. box rear cover plate and secure with previously removed bolts.
94. Lower hoist and disconnect lifting chains from eyes.
95. Remove chains from hoist. 117. Position earth strap to transfer box stud and
96. Remove bolts securing lifting eyes to transmission and remove eyes. 118. Fit oxygen sensor multiplug bracket to transfer

holes.

position to engine dowels.

tighten to 45 Nm, 33 lbf ft.

jacks to position transmission assembly.

• NOTE: Do not fully raise transmission at
• this stage as access is required for
• connection of connectors to transfer box.

locations.

and mounting bracket.

nuts and bolts.

nuts and bolts.

NOTE: Position earth lead to mounting fixing.

secure with fixings.

transfer box.

beneath ramp.

NOTE: Position heat shield to cover plate fixing.

and secure with bolt.

NOTE: Apply a soap solution to aid fitment of cable to body.

secure with nut.

box earth bolt and secure with nut.