Workshop Manuals Factory service & repair Land Rover
01 Introduction02 General information03 Information04 Maintenance05 Engine - K Series06 Engine - L Series07 Emission control08 Engine management system - MEMS09 Engine management system - EDC10 Fuel delivery system11 Cooling system - K Series12 Cooling system - L Series13 Manifold & exhaust systems14 Clutch15 Manual gearbox - PG116 Transfer box - IRD17 Drive shafts18 Rear axle and final drive19 Steering20 Front suspension21 Rear suspension22 Brakes23 Restraint systems24 Body25 Heating & ventilation26 Air conditioning27 Wipers & washers28 Electrical29 Instruments
Land Rover Freelander Workshop Manual (1998-2000)24 · Body
24 · Body & interior

Glove box

Make
Land Rover
Model
Freelander Workshop Manual
Year
1998–2000
Section
Interior trim components › Glove box
BodyGlove box

GLOVE BOX

Service repair no - 76.52.03

Remove

  1. Open glove box lid.
  2. Remove glove box mat.
Glove box – Remove glove box mat.
  1. Release illumination lamp from glove box.
  2. Remove 4 screws and remove glove box.

Refit

  1. Position glove box and tighten screws.
  2. Position and secure illumination lamp.
  3. Fit glove box mat.
  4. Close glove box lid.

HEADLINING - 5 DOOR

Service repair no - 76.64.01 Service repair no - 76.64.15

Remove

  1. Remove both A’ post trims. See this section.
  2. Remove both rear quarter upper trim casings. See this section.
  3. Remove both sun visors. See this section.
Headlining - 5 door – Remove both sun visors. See this section.
  1. Remove screw from each sun visor clip and collect clips.
  2. Remove screw covers and screws from grab handles and remove grab handles.
  3. Remove grab handle blanking plugs.

Parts & tools for this job For 1998 Land Rover Freelander

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.