Engine Coolant Temperature Gauge (Instruments) (page 2 of 2)

Left and Right Hand Indicators The LH and RH indicator warning lamps flash in time with the exterior direction indicators when they are operated. If either warning lamp flashes very rapidly, this indicates that one of the front or rear exterior indicator bulbs has failed.

When hazard warning lamps are operative, both direction indicator warning lamps flash simultaneously with the exterior indicators.

Headlamp Main Beam The headlamp main beam warning lamp illuminates when the headlamps are switched to main beam or the headlamp flash is operated.

Glow Plug (Diesel Models Only) The glow plug warning lamp illuminates when the ignition is switched to position II. The lamp illuminates on a timer from the ECM. The period for which the lamp is illuminated is dependent on engine coolant temperature and the engine should not be started until the lamp has extinguished.

Seat Belt (Selective Markets Only) The lamp illuminates when the ignition is switched to position II. When the seat belt buckle is secured in the stalk, a switch in the stalk extinguishes the lamp.

SRS The SRS lamp illuminates for approximately 5 seconds when the ignition is switched to position II for a bulb check. If the lamp remains illuminated or illuminates when the engine is running, the SRS has a fault which must be rectified as soon as possible.

Malfunction Indicator Lamp (MIL) (Service Engine Soon – NAS) – Petrol Engines Only The MIL illuminates at all times when the ignition is in position II and the engine is not running. If the lamp remains illuminated or illuminates when the engine is running, a fault has occurred in the engine emission control system or an emission related automatic gearbox fault has occurred. Stop the vehicle and switch off the ignition for at least 30 seconds. If the lamp illuminates after the engine is restarted, rectification must be sought as soon as possible to avoid potential engine or gearbox damage and excessive exhaust emissions.

Anti-Lock Braking System (ABS) The ABS lamp illuminates when the ignition is switched to position II and extinguishes after the engine is started. If the lamp illuminates at any other time, a fault has occurred in the ABS and should be rectified at the earliest opportunity.

Door Open The lamp illuminates if any side door, the tail door or the bonnet is open and the ignition switch is in position II.

Hazard Warning The lamp illuminates alternately with the direction indicators and direction indicator warning lamps when the hazard warning switch is operated.

Hill Descent Control Information The lamp illuminates for approximately 2 seconds when the ignition is switched to position II for a bulb check. The lamp illuminates when the driver selects Hill Descent Control (HDC), to inform the driver that the system is enabled. If the lamp flashes, the system cannot enable HDC due to excessive speed or incorrect gear selection.

Hill Descent Control Fault The lamp illuminates for approximately 2 seconds when the ignition is switched to position II for a bulb check. The lamp illuminates if a fault is detected within the HDC system, providing the driver with a visible warning. The lamp is illuminated for a short period when the ignition is switched to position II.

Handbrake and Brake System In some markets, the lamp illuminates for approximately 2 seconds when the ignition is switched to position II for a bulb check. The lamp illuminates when the handbrake is applied. If the lamp illuminates when the handbrake is released, urgent attention is required to the braking system.