L322 Range Rover Service Procedures
AIR CONDITIONING
82-8
REPAIRS
7. Evenly and progressively tighten compressor
mounting bolts to 25 Nm (18 lbf.ft).
8. Lubricate new 'O' rings with clean refrigerant oil
and fit to evaporator pipes
9. Position A/C pipes to compressor, fit bolts and
tighten to 22 Nm (16 lbf.ft).
10. Connect multiplug to compressor.
11. Fit tensioner arm assembly and tighten Allen
bolt to 10 Nm (7 lbf.ft).
12. Fit compressor drive belt.
Drive belt - compressor - Td6.
13. Fit viscous coupling.
14. Fit turbocharger intake duct.
Td6, REPAIRS, Duct- intake - turbocharger.
15. Recharge A/C system.
RECOVERY, RECYCLING AND
RECHARGING, Refrigerant recovery -
recycling and recharge.
16. Connect battery earth lead.
17. Remove stands and lower vehicle.
Compressor - V8
$% 82.10.20
Before disconnecting the battery, ensure all text and
cautions in the battery disconnection section are
observed.
GENERAL INFORMATION, Electrical
Remove
1. Position vehicle on lift.
2. Disconnect battery earth lead.
3. Recover refrigerant from A/C system.
RECOVERY, RECYCLING AND
RECHARGING, Refrigerant recovery -
recycling and recharge.
Receiver drier need only be changed under the
following circumstances. There is dirt in the
refrigerant circuit ( e.g. compressor seizure ).
The system is leaking and refrigerant has been
lost to atmosphere. Refrigerant circuit has
been open more than 24 hours due to repair.
4. Remove air intake pipe.
V8, REPAIRS, Hose - air flow meter to
throttle body.
5. Remove A/C compressor drive belt.
6. Remove 2 bolts securing A/C compressor drive
belt adjusting plate to sump.
7. Position A/C tensioner toward crankshaft pulley
to aid removal of A/C compressor.