L322 Range Rover Service Procedures
GENERAL INFORMATION
03-17
North America
SPX Corporation,
665, Eisenhower Drive,
Owatonna,
MN 55060,
USA
(
00 18 772979110
)
00 18 005787375
Australia
SPX Australia,
28, Clayton Road,
Notting Hill,
Victoria 3168,
Australia
(
00 (61) 00395446222
)
00 (61) 00395445222
e-mail: [email protected]
Japan and East Asia
Jatek Ltd,
5 - 53, Minawacho 2-chome,
Kohoku-ku,
Yokohama,
Kanagawa 223-0051,
Japan
(
00 81 455627700
)
00 81 455627800
Rolling Road Testing
General
IMPORTANT: Use a four wheel rolling road for
brake testing if possible.
Four wheel rolling road
Provided that front and rear rollers are rotating at
identical speeds and that normal workshop safety
standards are applied, there is no speed restriction
during testing except any that may apply to the tyres.
CAUTION: Ensure that gearbox selector lever is
at 'N', hill descent control is not selected and
handbrake is released.
When checking brakes, run engine at idle speed to
maintain servo vacuum.
Two wheel rolling road
If brake testing on a two wheel rolling road, then the
following precautions must be taken:
l
Disconnect propeller shaft from the transfer box
shaft driving the axle whose wheels are NOT on
the rolling road.
l
Neutral selected in gearbox.