L322 Range Rover Service Procedures
MANIFOLD AND EXHAUST SYSTEM - V8
REPAIRS 30-2-11
10. Fit fuel rail with injectors to inlet manifold and fit
bolt.
11. Fit 2 new brackets to manifold and tighten 5
bolts to 10 Nm (7 lbf.ft).
12. Fit solenoid valve and connect vacuum pipe.
13. Fit 4 new gaskets and install inlet manifold.
14. Connect breather pipe and install inlet manifold
to studs.
15. Position brake servo vacuum pipe.
16. Fit 10 spacers and tighten 10 inlet manifold
securing nuts to 15 Nm (11 lbf.ft).
17. Connect vacuum hose to inlet manifold front
cover.
18. Connect brake vacuum hose and secure with
clip.
19. Connect 2 breather hoses and secure with 2
clips.
20. Clean fuel hose connections.
21. Connect fuel feed hose to fuel rail.
22. Connect 2 cables to terminal post secure with
nut and fit terminal cover.
23. Fit air intake plenum.
24. Position injector harness.
25. Fit washer to fuel injector harness securing
stud.
26. Fit secondary air vacuum switching valve to RH
fuel injector securing stud.
27. Fit 2 nuts securing fuel injector harness to inlet
manifold and tighten.
28. Connect multiplug to charcoal canister purge
solenoid valve.
29. Position and secure engine harness to brackets
with clips.
30. Connect fuel injector harness multiplugs.
31. Connect alternator harness to 2 clips on engine
cover mounting brackets.
32. Fit fuel hose and mounting bracket to LH fuel
injector harness securing stud.
33. Fit vacuum reservoir and mounting bracket to
LH fuel injector harness securing stud.
34. Fit 2 nuts securing fuel injector harness to inlet
manifold and tighten.
35. Connect knock sensor multiplug.
36. Connect multiplug to CMP sensor.
37. Connect alternator harness to 4 clips.
38. Connect alternator multiplug.
39. Connect multiplug to charcoal canister purge
solenoid valve.
40. Connect VCC multiplug harness to clip.
41. Connect multiplugs to valve body solenoids.
42. Fit new cable ties, align and secure harness.
43. Connect multiplug to CMP sensor.
44. Connect multiplug to throttle body.
45. Connect multiplugs to ECT sensors.
46. Connect multiplugs to ignition coils.
47. Fit coil cover.
V8, REPAIRS, Cover - Ignition coils - RH.
48. Fit coil cover.
V8, REPAIRS, Cover - Ignition coils - LH.
49. Connect air intake hose.
V8, REPAIRS, Hose - air flow meter to
throttle body.
50. Connect battery earth lead.