Workshop Manuals Factory service & repair Land Rover
01 LT230T Transfer box Overhaul Manual - 3rd Edition02 03 04 05 INTRODUCTION06 07 08 TRANSFER BOX
Land Rover LT230 Transfer Box08 · TRANSFER BOX
08 · General

Differential lock warning lamp switch - adjust

Make
Land Rover
Model
Gearboxes LT230 Transfer Box
Section
OVERHAUL › Differential lock warning lamp switch - adjust
TRANSFER BOXDifferential lock warning lamp switch - adjust
Differential lock warning lamp switch - adjust – Land Rover LT230 Transfer Box

TRANSFER BOX

48

OVERHAUL

Neutral warning lamp switch - if fitted

1. Apply Hylosil PL32 sealant to threads of

switch.

2. Fit washer, fit and tighten switch to 25 Nm (18

lbf.ft).

Differential lock warning lamp switch - adjust

NOTE: This procedure is only necessary
for switches fitted with a locknut.

1. Move differential lock selector fork to

differential locked position.

2. Connect a 12V test lamp and battery to

differential lock switch.

3. Screw switch in until test lamp is illuminated

then screw switch in a further 1/2 turn; tighten
locknut.

4. Disengage differential lock, check that test

lamp is extinguished.

5. Remove test lamp.
6. Up to serial no. 288709E: Apply grease to a

new gasket and fit to differential lock side
cover.

7. From serial no. 288709E: Apply sealant, Part

No. STC 3254 to mating face of differential lock
side cover.

8. Fit side cover.
9. Apply Loctite 290 to threads of side cover

bolts, fit bolts and tighten to 25 Nm (18 lbf.ft).

Parts & tools for this job For Land Rover Gearboxes

As an Amazon Associate we earn from qualifying purchases.