Workshop Manuals Factory service & repair Land Rover
01 LT230T Transfer box Overhaul Manual - 3rd Edition02 03 04 05 INTRODUCTION06 07 08 TRANSFER BOX
Land Rover LT230 Transfer Box08 · TRANSFER BOX
08 · General

High/low cross shaft and housing

Make
Land Rover
Model
Gearboxes LT230 Transfer Box
Section
OVERHAUL › High/low cross shaft and housing
TRANSFER BOXHigh/low cross shaft and housing
High/low cross shaft and housing – Land Rover LT230 Transfer Box

TRANSFER BOX

OVERHAUL

19

Mainshaft input gear

1. Check gear teeth for cracks, chipping and

uneven wear.

2. Check that cross drillings in shaft are clear.

NOTE: Early transfer boxes fitted with an
oil feed plate do not have cross drilled
shafts. If a replacement input gear and

shaft is to be fitted, the shaft will be cross drilled
and it will not be necessary to fit the oil feed
plate.

Defender only

3. Check that ends of dog teeth are not

rounded-off or chipped.

High/low cross shaft and housing

1. Check mating surfaces of cross shaft and

drilling in housing for wear.

2. Check core plug in housing for signs of

leakage or corrosion, apply Loctite 326 to
replacement plug.

3. Check high/low selector finger for wear.
4. Measure across widest portion of finger:

Finger width = 15.90 to 15.95 mm (0.625 to
0.627 in)

Parts & tools for this job For Land Rover Gearboxes

As an Amazon Associate we earn from qualifying purchases.