High/low selector fork and shaft
- Make
- Land Rover
- Model
- Gearboxes LT230 Transfer Box
- Section
- OVERHAUL › High/low selector fork and shaft
TRANSFER BOX
OVERHAUL
23
Mainshaft input gear bearing housing
1. Check bearing track recess in housing for
damage, rectify or replace housing as
necessary.
High/low selector fork and shaft
NOTE: There is no need to remove
selector fork from shaft unless fork or
shaft is to be replaced. If fork is removed,
coat threads of setscrew with Loctite 290 prior to
assembly.
1. Check detent grooves in shaft for wear.
2. Check high/low selector finger groove width in
shaft:
Groove width = 16.0 to 16.1 mm (0.63 to 0.64
in)
Parts & tools for this job For Land Rover Gearboxes
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLSocket setSearch: socket set metric
- BOOKHaynes manualSearch: Haynes manual Land Rover Gearboxes
As an Amazon Associate we earn from qualifying purchases.