Range Rover P38
60
FRONT SUSPENSION
NEW RANGE ROVER
14
REPAIR
DRIVE SHAFT AND HUB ASSEMBLY
Service repair no - 60.25.01
Remove
NOTE: This procedure gives removal
instructions for the drive shaft and oil seal,
plus the hub, bearing and drive flange
assembly.
1. Remove centre cap from front wheel, release
stake from drive shaft nut. Slacken nut.
NOTE: If the hub and drive shaft are to be
removed as an assembly, it is not
necessary to slacken the drive shaft nut.
2. Raise the vehicle.
WARNING: Support on safety stands.
3. Remove brake disc shield.
See BRAKES,
Repair.
4. Release ABS sensor harness from brackets on
hub and axle.
5. Release sensor from hub.
6. Remove sensor bush.
7. Remove 4 bolts securing hub to carrier.