Range Rover P38
ELECTRONIC AIR SUSPENSION
17
REPAIR
Refit
6. Clean bush mating faces in rod.
7. Fit replacement bushes centrally in rod.
CAUTION: When pressing in the new
bushes ensure that pressure is applied to
ONLY the outer edge of the bush, NOT to
the rubber inner.
8. Fit panhard rod to axle and chassis.
9. Fit securing nut and bolt. Tighten to
200Nm.
(148 lbf.ft)
10. Fit securing bolt. Tighten to
200 Nm. (148 lbf.ft)
11. Fit locking plate and secure with screw. Tighten
screw Tighten to
20Nm (15 lbf.ft)
12. Remove safety stands. Lower vehicle.
RADIUS ARM AND BUSHES
Service repair no - 60.10.16
Remove
1. Depressurise air suspension.
See this section.
2. Remove anti-roll bar.
See this section.
3. Remove front road wheel.
4. Remove nut, disconnect track rod from swivel
hub. Move rod aside.
5. Remove nut, disconnect height sensor link from
radius arm.
6. Support axle on a jack.
7. Remove nuts and bolts securing radius arm to
axle.
8. Remove nut securing radius arm to chassis
bracket.
9. Remove radius arm.
10. Press bushes from radius arm using
LRT-60-004.