Workshop Manuals Factory service & repair Land Rover
01 Range Rover Classic - 199502 01 - INTRODUCTION03 04 - GENERAL SPECIFICATION DATA04 05 - ENGINE TUNING DATA05 06 07 - GENERAL FITTING REMINDERS07 09 - LUBRICANTS, FLUIDS AND CAPACITIES08 10 - MAINTENANCE09 12 - ENGINE - Tdi10 11 12 13 12 - ENGINE - V8i14 17 - EMISSION CONTROL15 19 - FUEL SYSTEM - Tdi16 19 - FUEL SYSTEM - MFI17 19 - FUEL SYSTEM - CRUISE CONTROL - V8i18 26 - COOLING SYSTEM - Tdi19 26 - COOLING SYSTEM - V8i20 30 - MANIFOLD AND EXHAUST SYSTEM21 33 - CLUTCH22 37 - MANUAL GEARBOX - R38023 41 - TRANSFER GEARBOX - BORG WARNER24 25 44 - AUTOMATIC GEARBOX - ZF26 27 28 47 - PROPELLER SHAFTS29 51 - REAR AXLE AND FINAL DRIVE30 31 54 - FRONT AXLE AND FINAL DRIVE32 33 34 57 - STEERING35 36 37 60 - FRONT SUSPENSION38 64 - REAR SUSPENSION39 68 - AIR SUSPENSION40 70 - BRAKES - NON ABS41 70 - BRAKES - ABS42 70 - BRAKES - ELECTRONIC TRACTION CONTROL43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 74 - WHEELS AND TYRES59 75 - SUPPLEMENTARY RESTRAINT SYSTEM60 76 - CHASSIS AND BODY61 62 63 64 80 - HEATING AND VENTILATION65 82 - AIR CONDITIONING66 84 - WIPERS AND WASHERS67 86 - ELECTRICAL
Land Rover Range Rover Classic58 · 74 - WHEELS AND TYRES
58 · Steering & suspension

TYRE PRESSURES

Make
Land Rover
Model
Range Rover Classic
Section
REPAIR › TYRE PRESSURES
74 - WHEELS AND TYRESTYRE PRESSURES
background image

74

WHEELS AND TYRES

2

REPAIR

When the indicators appear in two or more adjacent
grooves, at three locations around the tyre, a new tyre
must be fitted.

NOTE: Do not attempt to interchange
tyres, e.g. from front to rear, as tyre wear
produces characteristic patterns

depending on their position. If tyre position is
changed after wear has occured, the performance
of the tyre will be adversely affected.

NOTE: Territorial vehicle regulations
governing tyre wear MUST be adhered to.

WHEELS INSPECTION

Regularly check the condition of the wheels. Replace
any wheel that is bent, cracked, dented or has
excessive runout.

VALVES INSPECTION

Check condition of inflation valve. Replace any valve
that is worn, cracked, loose, or leaking air.

TYRE PRESSURES

Maximum tyre life and performance will be
obtained only if tyres are maintained at the correct
pressures.

Tyre pressures must be checked at least once a
month and at least once a week, preferably daily, if
the vehicle is used off road.

The tyre inflation pressure is calculated to give the
vehicle satisfactory ride and steering characteristics
without compromising tyre tread life. For
recommended tyre pressures in all conditions.

See

GENERAL SPECIFICATION DATA, Information,
Wheels and Tyres

American vehicles - A label attached to the inside
edge of the driver’s door also provides tyre pressure
information.

Always check tyre inflation pressures using an
accurate gauge and inflate tyres to the
recommended pressures only.

Check and adjust tyre pressures ONLY when the
tyres are cold, vehicle parked for three hours or more,
or driven for less than 3.2 km (2 miles) at speeds
below 64 km/h (40 mph). Do not reduce inflation
pressures if the tyres are hot or the vehicle has been
driven for more than 3.2 km (2 miles) at speeds over
64 km/h (40 mph), as pressures can increase by 0.41
bars (6 p.s.i) over cold inflation pressures.

Check ALL tyre pressures including the spare. Refit
the valve caps as they form a positive seal and keep
dust out of the valve.

Parts & tools for this job For Land Rover Range Rover

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.