Workshop Manuals Factory service & repair Mazda
01 General information02 Engine03 Engine performance04 Transmission05 Driveline and axles06 Suspension07 Brakes08 Steering09 Restraints10 Heating and air conditioning11 Electrical12 Accessories and equipment13 Body and cab accessories
Mazda MX-5 (NC) Factory Workshop Manual (2006-2008)02 · Engine
02 · Engine

Atomization inspection

Make
Mazda
Model
MX-5 (NC) Factory Workshop Manual
Year
2006–2008
Section
Fuel System › Atomization inspection
EngineAtomization inspection · page 1 of 2
ENGINE – Fuel System – figure
Fig. 51: Identifying F/P Connector Terminal
Courtesy of MAZDA MOTORS CORP.
  1. Turn the ignition switch to the ON position to operate the fuel pump.
  2. Measure the injection volume of each fuel injector.

Fuel injection volume

204-216 ml {204-216 cc, 12.5-13.1 cu in}/min

  1. Turn the ignition switch to off to stop the fuel pump.
  2. Install the fuel injector. (See FUEL INJECTOR REMOVAL/INSTALLATION [LF] .)
  3. Complete the "AFTER SERVICE PRECAUTION". (See AFTER SERVICE PRECAUTION [LF] .)

ATOMIZATION INSPECTION

  1. Inspect the atomization status.
    • If not normal, replace the fuel injector. (See FUEL INJECTOR REMOVAL/INSTALLATION

Parts & tools for this job For 2006 Mazda MX-5

As an Amazon Associate we earn from qualifying purchases.