Workshop Manuals Factory service & repair Mazda
01 General information02 Engine03 Engine performance04 Transmission05 Driveline and axles06 Suspension07 Brakes08 Steering09 Restraints10 Heating and air conditioning11 Electrical12 Accessories and equipment13 Body and cab accessories
Mazda MX-5 (NC) Factory Workshop Manual (2006-2008)02 · Engine
02 · Engine

Fuel line pressure inspection [lf]

Make
Mazda
Model
MX-5 (NC) Factory Workshop Manual
Year
2006–2008
Section
Fuel System › Fuel line pressure inspection [lf]
EngineFuel line pressure inspection [lf] · page 1 of 5
ENGINE – Fuel System – figure
Fig. 7: Identifying F/P Connector Terminal
Courtesy of MAZDA MOTORS CORP.
  1. Connect the negative battery cable.
  2. Turn the ignition switch to the ON position to operate the fuel pump.
  3. Verify that there is no fuel leakage from the pressurized parts.
    • If there is leakage, replace the fuel hoses and clips.
    • If there is damage on the seal on the fuel pipe side, replace the fuel pipe.

Standard

There shall be no leakage after 5 min.

  1. After reinstallation, repeat step 5 thru 6 in the fuel leakage inspection.

FUEL LINE PRESSURE INSPECTION [LF]

WARNING: Fuel line spills and leakage from the pressurized fuel system are dangerous. Fuel can ignite and cause serious injury or death and damage. To prevent this, complete the following inspection with the

Parts & tools for this job For 2006 Mazda MX-5

As an Amazon Associate we earn from qualifying purchases.