Workshop Manuals Factory service & repair Mazda
01 General information02 Engine03 Engine performance04 Transmission05 Driveline and axles06 Suspension07 Brakes08 Steering09 Restraints10 Heating and air conditioning11 Electrical12 Accessories and equipment13 Body and cab accessories
Mazda MX-5 (NC) Factory Workshop Manual (2006-2008)02 · Engine
02 · Engine

Injection volume inspection

Make
Mazda
Model
MX-5 (NC) Factory Workshop Manual
Year
2006–2008
Section
Fuel System › Injection volume inspection
EngineInjection volume inspection · page 1 of 3
ENGINE – Fuel System – figure
Fig. 48: Tilting Fuel Injector
Courtesy of MAZDA MOTORS CORP.

Fuel injector leakage amount

Less than 1 drop/2 min

  1. Stop the fuel pump using the following procedure:

Using M-MDS

  1. Stop the fuel pump using the "FP" simulation function.

Not using M-MDS

  1. Turn the ignition switch to off to stop the fuel pump.
  2. Remove the battery cover.
  3. Disconnect the negative battery cable. (See BATTERY REMOVAL/INSTALLATION [LF] .)
  4. Remove the wire or equivalent securing the fuel injector.
  5. Install the fuel injector. (See FUEL INJECTOR REMOVAL/INSTALLATION [LF] .)
  6. Complete the "AFTER SERVICE PRECAUTION". (See AFTER SERVICE PRECAUTION [LF] .)

INJECTION VOLUME INSPECTION

Parts & tools for this job For 2006 Mazda MX-5

As an Amazon Associate we earn from qualifying purchases.