Workshop Manuals Factory service & repair Mazda
01 General information02 Engine03 Engine performance04 Transmission05 Driveline and axles06 Suspension07 Brakes08 Steering09 Restraints10 Heating and air conditioning11 Electrical12 Accessories and equipment13 Body and cab accessories
Mazda MX-5 (NC) Factory Workshop Manual (2006-2008)02 · Engine
02 · Engine

Injection volume inspection (page 2 of 3)

Make
Mazda
Model
MX-5 (NC) Factory Workshop Manual
Year
2006–2008
Section
Fuel System
EngineInjection volume inspection · page 2 of 3

WARNING: Fuel line spills and leakage from the pressurized fuel system are dangerous. Fuel can ignite and cause serious injury or death and damage. To prevent this, complete the following inspection with the engine stopped.

  1. Follow "BEFORE SERVICE PRECAUTION" before performing any work operations to prevent fuel from spilling from the fuel system. (See BEFORE SERVICE PRECAUTION [LF] .)
  2. Remove the battery cover.
  3. Disconnect the negative battery cable. (See BATTERY REMOVAL/INSTALLATION [LF] .)
  4. Remove the fuel injector. (See FUEL INJECTOR REMOVAL/INSTALLATION [LF] .)
  5. Connect the fuel injector to the fuel injector tester.
  6. Start the fuel pump using the following procedure:

Using M-MDS

  1. Connect the negative battery cable.
  2. Connect the M-MDS or equivalent to the DLC-2.
ENGINE – Fuel System – figure
Fig. 49: Locating DLC-2 Connector
Courtesy of MAZDA MOTORS CORP.
  1. Start the fuel pump using the "FP" simulation function.

Parts & tools for this job For 2006 Mazda MX-5

As an Amazon Associate we earn from qualifying purchases.