Rear wheel brake cylinder (page 3 of 3)

Refit

1. Connect cable to compensator and secure with clip.
2. Feed cable into vehicle.
3. Fit intermediate pipe heat shield. See MANIFOLD & EXHAUST SYSTEMS, Repairs.
4. Fit locknut to cable.
5. Position cable guide plate and seal, secure with screws.
6. Connect cable to handbrake lever and fit cable adjusting nut.
7. Adjust handbrake. See Adjustments.
8. Position carpet and secure to door seal and clips on bulkhead.
9. Extend seat belt and align to lower mounting. Fit lower mounting bolt, spacers and washers and tighten to 30 Nm.
10. Position seat belt stalk, spacer and washers, fit Torx bolt and tighten to 32 Nm.
11. Fit drivers front seat. See BODY, Seats and seat belts.