Flywheel

13. Position bracket to housing, fit lower bolts securing housing to gearbox and tighten to 25 Nm.
14. Fit upper bolts securing housing to engine and tighten to 25 Nm.
15. Fit steady bar to bracket on body and align to engine.
16. Fit washer between steady bar and engine.
17. Fit steady bar bracket to engine, fit bolt and tighten to 22 Nm.
18. Fit earth strap to bolt, fit bolt securing steady bar to engine and tighten to 22 Nm.
19. Fit bolt securing steady bar to body and connect earth strap.
20. Fit nut and tighten bolt to 22 Nm.
21. Remove protective sleeve 18G 1043 from primary gear splines.
22. Remove plugs from brake pressure reducing valve.
23. Clean brake pipe unions.
24. Connect brake pipes to pressure reducing valve and tighten unions to 14 Nm.
25. Fit clutch assembly and release bearing. See CLUTCH, Repairs.
26. Fit brake master cylinder. See BRAKES, Repairs.
27. Refill engine/gearbox with oil. See MAINTENANCEMaintenance.

FLYWHEEL

Service repair no - 12.53.07

Remove

1. Remove clutch assembly and release bearing. See CLUTCH, Repairs.