Workshop Manuals Factory service & repair Rover
01 Introduction02 Engine - L Series03 Emission control04 Engine management system - EDC05 Fuel delivery system - L Series06 Cooling system - L Series07 Clutch08 Automatic gearbox09 Steering10 Front suspension11 Brakes12 Body13 Air conditioning14 Electrical
Rover 600 Repair Manual Supplement (1993-1999)08 · Automatic gearbox
08 · Transmission

Symptom to component chart (page 2 of 2)

Make
Rover
Model
600 Repair Manual Supplement
Year
1993–1999
Section
Fault diagnosis
Automatic gearboxSymptom to component chart · page 2 of 2
Number of D4 warning light blinks while service check connector is jumpedD4 warning lightPossible CauseSymptom
9Blinks• Disconnected countershaft speed sensor connector • Short or open in the countershaft speed sensor wire • Faulty countershaft speed sensor.• Lock-up clutch does not engage.
10Blinks• Disconnected engine coolant temperature (ECT) sensor connector. • Short or open in ECT sensor wire • Faulty ECT sensor
11OFF• Disconnected ignition coil connector • Short or open in ignition coil wire • Faulty ignition coil• Lock-up clutch does not engage
14OFF• Short or open in FAS (BRN/WHT) wire between the D16 terminal and the ECM. • Trouble in the ECM
15OFF• Disconnected mainshaft speed sensor connector • Short or open in mainshaft speed sensor wire • Faulty mainshaft speed sensor• Transmission jerks hard when shifting.

If the self-diagnosis D4 warning light does not blink, perform an inspection according to the table below.

SymptomProbable cause
Lock-up clutch does not have duty operation (ON-OFF)Check A/C signal with A/C on
Lock-up clutch does not engage. Shift lever cannot be moved from P position with the brake pedal depressed.Check A/C signal with A/C on Check brake switch signal
  • If a customer describes the symptoms for codes 3, 6, or 11, yet the D4 warning light is not blinking, it will be necessary to recreate the symptom by test driving, and then checking the D4 warning light with the ignition still ON.
  • If the D4 warning light displays codes other than those listed or stays lit continuously, the TCM is faulty.
  • Sometimes the D4 warning light and the PGM-Fi warning light may come on simultaneously. If so, check the PGM-Fi system according to the number to of blinks on the warning light, then reset the the memory by removing the BACK UP (RADIO) fuse (7.5A) in the engine compartment fuse/relay box for more than 10 seconds. Drive the vehicle for several minutes at speeds above 30 mph (50 km/h), then recheck the warning light.

Parts & tools for this job For 1993 Rover 600

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.