Leon Mk1
| Primary shaft, secondary shaft (drive pinion shaft), differential and control bars: removing and refitting |
| 1 - | Left outlet shaft |
| 2 - | Safety ring |
| q | Must always be replaced |
| 3 - | Seal ring |
| q | Must always be replaced |
| 4 - | Oil stopper, 60 Nm |
| 5 - | Retainer bolt, 35 Nm |
| q | Screw in, applying sealant or protector material -D 000 600 A2-. |
| 6 - | Reverse light switch, 20 Nm |
| q | Screw in, applying sealant or protector material -D 000 600 A2-. |
| 7 - | Gearbox housing |
| q | If it has to be replaced, adjust the differential → Chapter |
| q | Repairing the housing → Chapter |
| 8 - | Secondary shaft |
| q | Dismantling and assembling → Chapter |
| 9 - | Control bar with forks connecting 1st to 4th gears |
| 10 - | Control bar for reverse gear and 5th gear |
| 11 - | Primary shaft |
| q | Dismantling and assembling → Chapter |
| 12 - | O-ring |
| 13 - | Washer |
| 14 - | Shaft for reverse gear pinion |
| 15 - | Reverse gear pinion |
| q | Fit with the shaft when assembling |
| 16 - | Housing centring bushings |
| q | 2 units |
| 17 - | Clutch housing |
| q | If it has to be replaced, adjust the differential → Chapter |
| q | Repairing the housing → Chapter |
| 18 - | Right outlet shaft |
| 19 - | Hexagonal bolt, M8×55, 25 Nm |
| 20 - | Washer |
| 21 - | Differential |
| q | Dismantling and assembling → Chapter |
| 22 - | Hook |
| 23 - | Hexagonal bolt, M8×45, 25 Nm |
| 24 - | Hook |