BOLTS, NUTS AND SCREWS - Toyota Hilux AN120/AN130 2015-2018 Workshop Manual
- Make
- Toyota
- Model
- Hilux Toyota Hilux AN120/AN130 2015-2018 Workshop Manual
- Section
- REPAIR INSTRUCTIONPRECAUTION › BOLTS, NUTS AND SCREWS - Toyota Hilux AN120/AN130 2015-2018 Workshop Manual
BOLTS, NUTS AND SCREWS
d. GASKETS
i. When necessary, use a sealer on gaskets to prevent leaks.
e.
BOLTS, NUTS AND SCREWS
i. Carefully follow all the specifications for tightening torque. Always use a torque wrench. ii. Make sure that no foreign matter (burrs, paint, etc.) gets trapped under the heads of the bolts and nuts when tightening them.
f.

*a Incorrect *b Correct
FUSES
i. When inspecting a fuse, check that the wire of the fuse is not broken. ii. If the wire of a fuse is broken, confirm that there are no shorts in its circuit. iii. When a fuse is replaced, a fuse with the same amperage rating must be used. Part Illustration Symbol Abbreviation Name


FUSE FUSE


CIRCUIT CB BREAKER
g. CLIPS
i. The removal and installation methods of typical clips used for vehicle body parts are shown in the table below.
HINT: If a clip is damaged during a procedure, always replace the damaged clip with a new clip.
| Shape (Example) | Illustration / Procedures |
|---|---|
| Remove clips with clip remover or pliers. |
Parts & tools for this job For Toyota Hilux
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLSocket setSearch: socket set metric
- BOOKHaynes manualSearch: Haynes manual Toyota Hilux
As an Amazon Associate we earn from qualifying purchases.