JACKING UP AND SUPPORTING VEHICLE - Toyota Hilux AN120/AN130 2015-2018 Workshop Manual
- Make
- Toyota
- Model
- Hilux Toyota Hilux AN120/AN130 2015-2018 Workshop Manual
- Section
- REPAIR INSTRUCTIONPRECAUTION › JACKING UP AND SUPPORTING VEHICLE - Toyota Hilux AN120/AN130 2015-2018 Workshop Manual
JACKING UP AND SUPPORTING VEHICLE
| rvice Information | 11/ of the assembly and for deformation and damage. | |
|---|---|---|
| 5 | Removal, installation, disassembly and assembly operations | of the assembly and for deformation and damage. When the assembly is complicated, take notes. For example, note the total number of electrical connections, bolts, or hoses removed. Add matchmarks to insure reassembly of components in the original positions. Temporarily mark hoses and their fittings if needed. · Clean and wash the removed parts if necessary and assemble them after a thorough check. · |
| 6 | Removed parts | Place the removed parts in a separate box to avoid mixing them up with the new parts or contaminating the new parts. · For non-reusable parts such as gaskets, O-rings and self-locking nuts, replace them with new ones as instructed in this manual. · Retain the removed parts for customer inspection, if requested. · |
| 7* | Checks to perform after work is finished | Make sure that removed and installed parts (oil filler cap, level dipstick, floor mat, etc.) are properly installed/tightened. · Make sure that none of the cloths or tools that were used have been left in the engine compartment or within the vehicle. · Check that there are no oil leaks. · |
CAUTION: *: Be sure to perform these checks properly. Not performing these checks properly after finishing work can lead to serious accident or injury.
b.
JACKING UP AND SUPPORTING VEHICLE
i. Care must be taken when jacking up and supporting the vehicle. Be sure to lift and support the vehicle at the proper locations.
c.
PRECOATED PARTS
i.

*a Seal Lock Adhesive
Precoated parts are bolts and nuts that are coated with a seal lock adhesive at the factory. ii. If a precoated part is retightened, loosened or moved in any way, it must be recoated with the specified adhesive. iii. When reusing a precoated part, clean off the old adhesive and dry the part with compressed air. Then apply new seal lock adhesive appropriate to that part. iv. Some seal lock agents harden slowly. You may have to wait for the seal lock adhesive to harden.
Parts & tools for this job For Toyota Hilux
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLSocket setSearch: socket set metric
- BOOKHaynes manualSearch: Haynes manual Toyota Hilux
As an Amazon Associate we earn from qualifying purchases.