SPIRAL CABLE - Toyota Hilux AN120/AN130 2015-2018 Workshop Manual
- Make
- Toyota
- Model
- Hilux Toyota Hilux AN120/AN130 2015-2018 Workshop Manual
- Section
- REPAIR INSTRUCTIONPRECAUTION › SPIRAL CABLE - Toyota Hilux AN120/AN130 2015-2018 Workshop Manual
SPIRAL CABLE
ix. Use a voltmeter/ohmmeter with high impedance (minimum = 10 kΩ) for troubleshooting electrical circuits.
x. Information labels are attached to the SRS components. Follow the instructions on the labels. xi. After work on the SRS is completed, check the SRS warning light.
b.
SPIRAL CABLE
i. The steering wheel must be fitted correctly to the steering column with the spiral cable at the neutral position, otherwise cable disconnection and other problems may occur. Refer to the information about correct installation of the steering wheel.
c.
STEERING PAD
i. Always place a removed or new steering pad with the deployment surface facing upward. Placing the steering pad with the deployment surface facing downward could cause a serious accident if the airbag deploys. Also, do not place anything on top of the steering pad. ii. Never measure the resistance of the airbag squib. This may cause the airbag to deploy, which could cause serious injury. iii. Grease or detergents of any kind should not be applied to the steering pad. iv. Store the steering pad in an area where the ambient temperature is below 93°C (199°F), the humidity is not high and there is no electrical noise.
v. Before using an electric welder anywhere on the vehicle, disconnect the center airbag sensor assembly connectors. These connectors contain shorting springs. This feature reduces the possibility of the airbag deploying due to current entering the squib wiring. vi. When disposing of the vehicle or steering pad by itself, the airbag should be deployed using SST before disposal. Deploy the airbag in a safe place away from electrical noise.
d.
FRONT PASSENGER AIRBAG ASSEMBLY
i. Always place a removed or new front passenger airbag assembly with the deployment surface facing upward. Placing the airbag assembly with the airbag deployment surface facing downward could cause a serious accident if the airbag deploys. ii. Never measure the resistance of the airbag squib. This may cause the airbag to deploy, which could cause serious injury. iii. Grease or detergents of any kind should not be applied to the front passenger airbag assembly. iv. Store the front passenger airbag assembly in an area where the ambient temperature is below 93°C (199°F), the humidity is not high and there is no electrical noise.
v. Before using an electric welder anywhere on the vehicle, disconnect the center airbag sensor assembly connectors. These connectors contain shorting springs. This feature reduces the possibility of the airbag deploying due to current entering the squib wiring. vi. When disposing of the vehicle or front passenger airbag assembly by itself, the airbag should be deployed using SST before disposal. Deploy the airbag in a safe place away from electrical noise. ASSEMBLY>DISPOSAL
e.
KNEE AIRBAG ASSEMBLY
i. Always place a removed or new knee airbag assembly with the airbag deployment surface facing upward. Placing the airbag assembly with the airbag deployment surface facing downward could cause a serious accident if the airbag deploys. ii. Never measure the resistance of the airbag squib. This may cause the airbag to deploy, which could cause serious injury.
Parts & tools for this job For Toyota Hilux
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLSocket setSearch: socket set metric
- BOOKHaynes manualSearch: Haynes manual Toyota Hilux
As an Amazon Associate we earn from qualifying purchases.