WHEN USING A BRAKE TESTER - Toyota Hilux AN120/AN130 2015-2018 Workshop Manual
- Make
- Toyota
- Model
- Hilux Toyota Hilux AN120/AN130 2015-2018 Workshop Manual
- Section
- REPAIR INSTRUCTIONPRECAUTION › WHEN USING A BRAKE TESTER - Toyota Hilux AN120/AN130 2015-2018 Workshop Manual
WHEN USING A BRAKE TESTER
Make sure that the transfer is in 2WD mode. ii. w/ VSC: Enter Inspection Mode to disable TRC and VSC control. iii. Place the rear wheels onto the rollers. iv.

Secure the vehicle with suitable chains or straps.
v. Start the engine, and then measure the vehicle speed while increasing the speed gradually. vi. After the test is finished, decrease the speed gradually, and then stop the vehicle.
b.
WHEN USING A BRAKE TESTER
NOTICE:
· A high-speed type brake tester cannot be used.
· The vehicle speed should be less than 0.5 km/h (0.3 mph).
· Follow all usage and safety procedures in the operator's manual for the brake tester.
i. for 4WD: Make sure that the transfer is in 2WD mode. ii. w/ VSC: Enter Inspection Mode to disable TRC and VSC control. iii. Position the wheels to be tested (front or rear) on the tester. iv. for Manual Transmission: Move the shift lever to neutral.
v. for Automatic Transmission: Move the shift lever to N. vi. Start the engine to allow normal brake booster operation. vii. Operate the brakes to perform the test.
c.
WHEN USING A CHASSIS DYNAMOMETER
i. for 4WD: Make sure that the transfer is in 2WD mode. ii. w/ VSC: Enter Inspection Mode to disable TRC and VSC control. iii. Place the rear wheels onto the rollers. iv. Make sure that the vehicle is securely fixed in place.
Parts & tools for this job For Toyota Hilux
- PARTBrake padsSearch: Toyota Hilux brake pads
- TOOLBrake bleeder kitSearch: one man brake bleeder kit
- FLUIDBrake fluidSearch: brake fluid
As an Amazon Associate we earn from qualifying purchases.