WHEN USING AN ON-VEHICLE BALANCER - Toyota Hilux AN120/AN130 2015-2018 Workshop Manual
- Make
- Toyota
- Model
- Hilux Toyota Hilux AN120/AN130 2015-2018 Workshop Manual
- Section
- REPAIR INSTRUCTIONPRECAUTION › WHEN USING AN ON-VEHICLE BALANCER - Toyota Hilux AN120/AN130 2015-2018 Workshop Manual
WHEN USING AN ON-VEHICLE BALANCER
v.

Secure the vehicle with suitable chains or straps.
CAUTION: Confirm that the vehicle is securely immobilized.
NOTICE:
· Do not brake or accelerate suddenly.
· Follow all usage and safety procedures in the operator's manual for the chassis dynamometer.
d.
WHEN USING AN ON-VEHICLE BALANCER
i. Raise the vehicle until all 4 wheels are off the ground. ii. Support the vehicle with safety stands at an appropriate height. Make sure that vehicle does not lean in any direction, and that the tires are completely clear of the floor. iii. Place the vibration pick-up unit into position for the wheel to be measured*1. iv. Release the parking brake.
v. Check that no dragging force exists when turning each wheel by hand. vi. Put the wheel balancer in position. vii. The wheel balance measurement should be done by using both the engine and the wheel balancer drive roller to spin the wheels.
CAUTION: Confirm that the vehicle is securely immobilized.
NOTICE:
· for Manual Transmission: Start the engine and increase the vehicle speed gradually with the shift lever in a position other than neutral or reverse.
· for Automatic Transmission: Start the engine and increase the vehicle speed gradually with the shift lever in D.
· Do not accelerate or decelerate suddenly.
· Deceleration should be done by braking gradually.
· Make sure that no one is standing in front of or behind the spinning wheels.
· The measurement should be done quickly.
· Follow all usage and safety procedures in the operator's manual for the wheel balancer.
HINT: *1: Different on-vehicle wheel balancers have different requirements for mounting the vibration pick- up unit(s). Refer to the operator's manual for the wheel balancer to confirm requirements for use.
PRECAUTIONS FOR TOWING REAR WHEEL DRIVE VEHICLES
Parts & tools for this job For Toyota Hilux
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLSocket setSearch: socket set metric
- BOOKHaynes manualSearch: Haynes manual Toyota Hilux
As an Amazon Associate we earn from qualifying purchases.