SEAT SIDE AIRBAG ASSEMBLY - Toyota Hilux AN120/AN130 2015-2018 Workshop Manual
- Make
- Toyota
- Model
- Hilux Toyota Hilux AN120/AN130 2015-2018 Workshop Manual
- Section
- REPAIR INSTRUCTIONPRECAUTION › SEAT SIDE AIRBAG ASSEMBLY - Toyota Hilux AN120/AN130 2015-2018 Workshop Manual
SEAT SIDE AIRBAG ASSEMBLY
iii. Grease or detergents of any kind should not be applied to the knee airbag assembly. iv. Store the knee airbag assembly in an area where the ambient temperature is below 93°C (199°F), the humidity is not high and there is no electrical noise.
v. Before using an electric welder anywhere on the vehicle, disconnect the center airbag sensor assembly connectors. These connectors contain shorting springs. This feature reduces the possibility of the airbag deploying due to current entering the squib wiring. vi. When disposing of the vehicle or a knee airbag assembly by itself, the airbag should be deployed using SST before disposal. Deploy the airbag in a safe place away from electrical noise.
f.
SEAT SIDE AIRBAG ASSEMBLY
i. Always place a removed or new seat side airbag assembly with the airbag deployment surface facing upward. ii. Never measure the resistance of the airbag squib. This may cause the airbag to deploy, which could cause serious injury. iii. Grease or detergents of any kind should not be applied to the seat side airbag assembly. iv. Store the seat side airbag assembly in an area where the ambient temperature is below 93°C (199°F), the humidity is not high and there is no electrical noise.
v. Before using an electric welder anywhere on the vehicle, disconnect the center airbag sensor assembly connectors. These connectors contain shorting springs. This feature reduces the possibility of the airbag deploying due to current entering the squib wiring. vi. When disposing of the vehicle or a seat side airbag assembly by itself, the airbag should be deployed using SST before disposal. Deploy the airbag in a safe place away from electrical noise. for Manual Seat:Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>FRONT SEAT SIDE AIRBAG ASSEMBLY(for Manual Seat)>DISPOSAL for Power Seat:Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>FRONT SEAT SIDE AIRBAG ASSEMBLY(for Power Seat)>DISPOSAL
g.
CURTAIN SHIELD AIRBAG ASSEMBLY
i. Always place a removed or new curtain shield airbag assembly in a clear plastic bag, and keep it in a safe place.
CAUTION: The plastic bag should be disposed of after use.
NOTICE: Never disassemble a curtain shield airbag assembly.
ii. Never measure the resistance of the airbag squib. This may cause the airbag to deploy, which could cause serious injury. iii. Grease or detergents of any kind should not be applied to the curtain shield airbag assembly. iv. Store the curtain shield airbag assembly in an area where the ambient temperature is below 93°C (199°F), the humidity is not high and there is no electrical noise.
v. Before using an electric welder anywhere on the vehicle, disconnect the center airbag sensor assembly connectors. These connectors contain shorting springs. This feature reduces the possibility of the airbag deploying due to current entering the squib wiring. vi. When disposing of the vehicle or a curtain shield airbag assembly by itself, the airbag should be deployed using SST before disposal. Deploy the airbag in a safe place away from electrical noise. ASSEMBLY>DISPOSAL
h.
SEAT OUTER BELT ASSEMBLY (SEAT BELT PRETENSIONER)
i. Never measure the resistance of the seat outer belt assembly. This may cause the pretensioner of the
Parts & tools for this job For Toyota Hilux
- TOOLOBD2 scanner with SRSSearch: OBD2 scanner ABS SRS
- TOOLTrim removal tool kitSearch: trim removal tool kit
As an Amazon Associate we earn from qualifying purchases.