CENTER AIRBAG SENSOR ASSEMBLY - Toyota Hilux AN120/AN130 2015-2018 Workshop Manual
- Make
- Toyota
- Model
- Hilux Toyota Hilux AN120/AN130 2015-2018 Workshop Manual
- Section
- REPAIR INSTRUCTIONPRECAUTION › CENTER AIRBAG SENSOR ASSEMBLY - Toyota Hilux AN120/AN130 2015-2018 Workshop Manual
CENTER AIRBAG SENSOR ASSEMBLY
seat outer belt assembly to deploy, which could cause serious injury. ii. Never disassemble the seat outer belt assembly. iii. Never install the seat outer belt assembly on another vehicle. iv. Store the seat outer belt assembly in an area where the ambient temperature is below 80°C (176°F), the humidity is not high and there is no electrical noise.
v. Before using an electric welder anywhere on the vehicle, disconnect the center airbag sensor assembly connectors. These connectors contain shorting springs. This feature reduces the possibility of the airbag deploying due to current entering the squib wiring. vi. When disposing of the vehicle or a seat outer belt assembly by itself, the seat outer belt assembly should be deployed before disposal. Deploy the seat outer belt assembly in a safe place away from electrical noise. for Double Cab: Click hereVehicle Interior>SEAT BELT>FRONT SEAT OUTER BELT ASSEMBLY(for Double Cab)>DISPOSAL for Single Cab: Click hereVehicle Interior>SEAT BELT>FRONT SEAT OUTER BELT ASSEMBLY(for Single Cab)>DISPOSAL for Smart Cab: Click hereVehicle Interior>SEAT BELT>FRONT SEAT OUTER BELT ASSEMBLY(for Smart Cab)>DISPOSAL vii. As the seat outer belt assembly is hot after being deployed, allow some time for it to cool down sufficiently before disposal. Never apply water to cool down the seat outer belt assembly. viii. Grease, detergents, oil or water should not be applied to the seat outer belt assembly.
i.
CENTER AIRBAG SENSOR ASSEMBLY
i. Never reuse an airbag sensor assembly that has been involved in a collision where the SRS has deployed. ii. The connectors to the airbag sensor assembly should be connected or disconnected with the sensor placed on the floor. If the connectors are connected or disconnected while the airbag sensor assembly is not placed on the floor, the SRS may activate. iii. Work must be started at least 90 seconds after the ignition switch is turned off and the cable is disconnected from the negative (-) battery terminal, even if only loosening the set bolts of the airbag sensor assembly.
j.
WIRE HARNESS AND CONNECTOR
i. The SRS wire harness is integrated with the instrument panel wire harness assembly. All the connectors in the system are yellow. If the SRS wire harness becomes disconnected or a connector becomes broken, repair or replace it.
ELECTRONIC CONTROL
NOTICE: Certain systems need to be initialized after disconnecting and reconnecting the cable to the negative (-) battery terminal.
Parts & tools for this job For Toyota Hilux
- TOOLOBD2 scannerSearch: OBD2 scanner
- TOOLDigital multimeterSearch: automotive digital multimeter
- TOOLBack-probe test leadsSearch: back probe test leads
As an Amazon Associate we earn from qualifying purchases.