(Procedure "A") - Toyota Hilux Generation 7 2005-2010 Workshop Manual
- Make
- Toyota
- Model
- Hilux Toyota Hilux Generation 7 2005-2010 Workshop Manual
- Section
- (Procedure "A") - Toyota Hilux Generation 7 2005-2010 Workshop Manual
(Procedure "A")
EI–10
ENGINE IMMOBILISER – ENGINE IMMOBILISER SYSTEM
(b) Finish the automatic key code registration mode. The automatic key code registration mode can be forced to end when at least 1 key code for the master key has been registered. (1) Turn the ignition switch ON and OFF 5 times within 10 seconds using the already registered master key.
3.
PERFORM REGISTRATION OF ADDITIONAL KEY
(PROCEDURE "A")
(a) Register an additional key by using the intelligent tester.
HINT:
• A maximum of 5 master key codes and 3 sub-key codes can be registered.
• Registration mode will end if each step is not completed within the specified time.
• When the ignition cylinder or the key cylinder set is replaced, remove the transmitter module from the original master key. Then install this transmitter module to a new key and use the new key as the master key. If necessary, use this master key to register other keys.
NOTICE: When the ignition key cylinder has been replaced, locking and unlocking doors is possible with the new master key's transmitter module (taken from the original master key). However, the new master key will not be able to lock and unlock doors through the door key cylinder. Keep the original master key. If the new master key's transmitter module's battery fails, the original master key can be used to lock and unlock doors through the door key cylinder. Additional Registration
| Procedure | Time (Completion of operation) | Security indicator Condition |
|---|---|---|
| 1. Start | - | The indicator will blink until the first key is inserted. |
| 2. Insert the already registered master key in the ignition key cylinder and turn the ignition switch on. | ||
| 3. Intelligent tester operation: (1) Select IMMOBILISER. (2) Select ID UTILITY. (3) Select TRANS CODE REG. HINT: After completing the above operation, proceed to the next step in accordance with the prompts on the tester screen. | Within 120 seconds | OFF |
| 4. Remove the master key. | Within 20 seconds of the instruction on the tester. | ON |
| 5. Insert the key to be registered in the ignition key cylinder. | Within 10 seconds | |
| 6. After 60 sec. the key is registered. HINT: Security indicator goes off. | - | Blinking |
| 7. Next | OFF | |
| 8. End |
EI
Parts & tools for this job For Toyota Hilux
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLSocket setSearch: socket set metric
- BOOKHaynes manualSearch: Haynes manual Toyota Hilux
As an Amazon Associate we earn from qualifying purchases.