(Procedure "C") - Toyota Hilux Generation 7 2005-2010 Workshop Manual
- Make
- Toyota
- Model
- Hilux Toyota Hilux Generation 7 2005-2010 Workshop Manual
- Section
- (Procedure "C") - Toyota Hilux Generation 7 2005-2010 Workshop Manual
(Procedure "C")
EI–12
ENGINE IMMOBILISER – ENGINE IMMOBILISER SYSTEM
5.
REGISTRATION OF ECU COMMUNICATION ID
(PROCEDURE "C")
NOTICE:
• The ECU COMMUNICATION ID should be registered when the transponder key ECU assembly and/or the ECM is replaced in order to match these ECM COMMUNICATION ID
• The engine cannot be started unless the ECM COMMUNICATION ID matches. (a) Register the ECU communication ID

CG
SST TC DLC3 B087946E01 (1) Before operation, make sure that no key is in the ignition key cylinder. (2) Using SST, connect terminals TC and CG of the DLC3. SST 09843-18040 (3) Insert a key, of which the key code has already been registered, into the ignition key cylinder. (4) Turn the ignition switch ON (do not start the engine) and leave it as is for 30 minutes. (5) Turn the ignition switch OFF and disconnect terminals TC and CG. (6) Check that the engine starts.
HINT: After the engine has been started, delete DTC 2799 (indicating immobiliser communication failures in the ECM) by following either one of the operations below with the ignition switch OFF:
• Delete the DTC using intelligent tester.
• Disconnect the negative battery cable from the battery terminal for at least 30 seconds. EI
Parts & tools for this job For Toyota Hilux
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLSocket setSearch: socket set metric
- BOOKHaynes manualSearch: Haynes manual Toyota Hilux
As an Amazon Associate we earn from qualifying purchases.