Workshop Manuals Factory service & repair Vauxhall
Vauxhall Astra J05 · Body Systems
05 · Body & interior

Brake Pedal Position Sensor Calibration (Lighting)

Make
Vauxhall
Model
Astra J
Section
Lighting › Repair Instructions › Brake Pedal Position Sensor Calibration
Body SystemsBrake Pedal Position Sensor Calibration

Brake Pedal Position Sensor Calibration

Calibration Criteria


Note:  Do not apply the brake pedal during the brake pedal position sensor calibration procedure. Any movement of the brake pedal during this procedure will cause the calibration procedure to fail. If this occurs, the brake pedal position sensor calibration must be repeated.

Brake pedal position sensor calibration must be performed after the brake pedal position sensor or body control module (BCM) have been serviced. The calibration procedure will set the brake pedal position sensor home value. This value is used by the BCM to determine the action of the driver applying the brake system and to provide this information to the vehicle subsystems via serial data.

Calibration Procedure

1. Apply the parking brake.
2. Place the transmission in the PARK position for automatic transmission or NEUTRAL position for manual transmission.
3. Install a scan tool.
4. Clear all BCM DTCs before proceeding.
5. Navigate to the Configuration/Reset Functions menu of the BCM.
6. Select the Brake Pedal Position Sensor Learn procedure and follow the directions displayed on the screen.

Parts & tools for this job For Vauxhall Astra

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.