- Vectra B Workshop Manual
- General Vehicle Information
- A Maintenance, Body and Chassis Sheet Metal Parts, Frame
- B Paint
- C Body Equipment
- D Heating, Ventilation, Air Conditioning (HVAC)
- E Front Wheel Suspension, Wheels and Tyres
- F Rear Axle and Rear Wheel Suspension
- H Brakes
- J Engine and Engine Aggregates
- Repair Instructions
- Description and Operation
- Labour Time Allowances
- Other Information
- Technical Service Bulletins
- Technical Information
- OHC Petrol Engine
- DOHC Petrol Engine
- Diesel Engine
- Repair Instructions
- Description and Operation
- Diagnostic Information and Procedures
- Other Information
- Technical Service Bulletins
- Schematic and Routing Diagrams
- Technical Information
- General
- Repair Instructions
- 16V OHC Diesel Engine (X 20 DTL, X 20 DTH) Engine Number
- Checking and Adjustment Operations - Ribbed V-Belt Tensioner, Check
- Compression, Check
- Pressure Loss, Check
- Oil Temperature, Measure
- Oil Pressure, Check
- Oil Consumption, Measure
- Engine, Lock at 1st Cylinder TDC (Timing, Check)
- Timing, Adjust, Option 1: Fuel injection pump retaining pin does not fit in fuel injection pump flange retaining bore
- Option 2: Camshaft test gauge cannot be inserted in cylinder head.
- Low-Pressure System (Fuel System), Check for Leaks
- Air Cleaner Housing, Air Ducts - Illustration (X 20 DTL)
- Cooling System - Cooling System, Top Up and Bleed
- Cooling System, Check for Leaks
- Engine, Check for Leaks, (CO Content in Cooling System)
- Coolant Temperature Sensor, Remove and Install
- Heater Element, Remove and Install (LHD)
- Engine, Remove and Install
- Technical Data - Recommended Torque Values
- Sealants, Lubricants and Locking Compounds
- Air Cleaner Housing, Air Ducts - Illustration (X20DTH)
- Charge Air Hose - Upper Part, Remove and Install (X 20 DTH)
- Charge Air Hose - Lower Part, Remove and Install (X 20 DTH)
- Intercooler, Remove and Install (X 20 DTH without Air Conditioning) conditioning)
- Intercooler, Remove and Install (X 20 DTH with Air Conditioning) conditioning)
- Engine, Repair Using Short-block
- Illustration - Engine Compartment Vacuum Routing
- Heater Element Temperature Sensor, Remove and Install
- Valve Bridges, Remove and Install
- Oil Dipstick Guide Tube, Remove and Install (X 20 DTH)
- Charge Pressure Control Solenoid Valve, Remove and Install
- Switchover Valves Solenoid Valve, Remove and Install
- Switchover Valves Vacuum Unit, Remove and Install
- Exhaust Gas Recirculation Solenoid Valve, Remove and Install
- Starter - Starter, Remove and Install reinstallation
- Accelerator Pedal - Accelerator Pedal, Remove and Install
- Accelerator Position Sensor, Remove and Install remove and install
- Immobiliser with Immobiliser Control Unit Transponder, Remove and Install Install
- Description and Operation
- Component Locator
- Specifications
- Special Tools and Equipment
- Other Information
- Seals and Seal Rings
- Ribbed V-Belt
- Engine Damping Block
- Oil Circulating
- Timing Gear Case
- Cylinder Block
- Cylinder Head
- Vacuum Pump
- Fuel Injection Systems
- Engine Electrics
- Cooling System
- Turbo-Charging
- K Clutch and Transmission
- L Fuel and Exhaust System
- M Steering
- N Electrical Equipment and Instruments
- R Accessories