Workshop Manuals Factory service & repair Fiat
01 General information02 Specifications03 Manufacturing data and tolerances04 Tightening torques05 Fluids and lubricants06 Maintenance07 Diagnostic checks08 Engine09 Clutch10 Gearbox and differential11 Axles and driveshafts12 Brakes13 Steering14 Suspension and wheels15 Heating, air conditioning and auxiliary units16 Electrical equipment17 Body fittings18 Body panels and frame19 Wiring diagrams and electrical functions20 Wiring harnesses21 Connectors and pin-outs22 Fault diagnosis23 Special tools
Fiat Bravo Factory Service Manual (2007-2014)08 · Engine
08 · Engine

Throttle case - r + r

Make
Fiat
Model
Bravo Factory Service Manual
Year
2007–2014
Section
Petrol injection system › Throttle case - r + r
EngineThrottle case - r + r

THROTTLE CASE - R + R

Operation 1056B14 · MULTI-POINT INJECTION SYSTEM (MPI)

1.4 16v

Removing

If the throttle body is replaced, run the following self-learning procedure:

- with the engine switched off, turn the ignition key to MAR without pressing the accelerator pedal and with the engine temperature between 5.25°C and 100.5°C for 29 seconds.

Op. 1048A32 HOSE FROM AIR FILTER TO INTAKE MANIFOLD - R + R

1. Detach the electrical connection for the throttle body.

DescriptionConnector
1Integrated throttle body actuatorSee N075 BUILT-IN THROTTLE BODY ACTUATOR

2. Undo bolts (2a) and move mounting bracket (2b) to the side complete with the injection-ignition system control unit.

3. Undo remaining bolt (3a) and remove throttle body (3b).

THROTTLE CASE - R + R

Refitting

- Place the throttle body back in its housing and secure it using the bolt.

- Refit the injection-ignition system control unit mounting bracket in its housing and secure it using the bolts.

- Connect the electrical connection for the throttle body.

Op. 1048A32 HOSE FROM AIR FILTER TO INTAKE MANIFOLD - R + R

1.4 16v TJet

Removing

Op. 1048B30 AIR SUPPLY HOSE FROM RIGID PIPE TO THROTTLE BODY - REPLACE

1. Detach the electrical connection for the throttle body.

DescriptionConnector
1Integrated throttle body actuatorSee N075 BUILT-IN THROTTLE BODY ACTUATOR

2. Undo bolts (2a) and remove throttle body (2b).

- Remove the O-ring from the intake chamber.

THROTTLE CASE - R + R

Refitting

- Fit a new O-Ring on the intake chamber.

- Place the throttle body back in its housing and tighten the bolts.

- Connect the electrical connection for the throttle body.

Op. 1048B30 AIR SUPPLY HOSE FROM RIGID PIPE TO THROTTLE BODY - REPLACE

Parts & tools for this job For 2007 Fiat Bravo

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.