BRAKE LIGHTS - DESCRIPTION

DESCRIPTION

The vehicle brake lights are located at the rear in the side light clusters and in the special central third brake light, consisting of 8 all glass type bulbs.

They are operated each time the brake pedal is pressed via the special switch on the actual pedal.

The control function is activated by the enablement signals (key ON) and the command from the switch contact.

The engagement of the side brake lights is managed by the Body Computer, that of the third brake light is managed directly by the switch on the pedal.

The brake light check function monitors that the side lights are operating correctly: the following are checked:

- open circuit (bulb missing or wiring interrupted)

- short-circuit to earth (bulb s.c. or wiring s.c. to earth)

- short circuit to battery voltage (wiring short circuited to Vbatt)

The continuity of the fuse protecting the switch on the brake pedal is also checked.

When one of the situations described above is ascertained, the Body Computer makes the failure status available to the CAN: a special "lights failure" warning light comes on in the instrument panel and, at the same time, the information is shown in the display by means of the specific symbol.