Automatic programme change (REGIONAL)

Automatic programme change (REGIONAL)

When the RDS programme consists of various regional broadcasts, the radio may switch between transmitters, selecting the one with the most powerful signal.

The frequency selection buttons required are button 5 (1) for switching the function on and button 4 (2) for switching it off.

The messages displayed will be "RES ON" when the function is switched on and "RES OFF" when the function is switched off.

LOC function

This makes it possible to search for FM frequencies according to their transmission power.

With the LOC function selected, the radio system searches for the most power broadcasting stations whilst if the function is not selected the search is also extended to less powerful transmissions.

To activate the LOC function, press the frequency selection button 5 (1) until the message "LOC ON" appears on the display. To deactivate the function selected previously, press frequency selection button 4 (2) until the message "LOC OFF" appears on the display.

MONO function

The MONO function makes it possible to set the radio equipment to stereo or mono reproduction. In the case of a stereo broadcast, there are two different channels, whilst in the case of a MONO broadcast there is one channel only. For good quality sound, the setting should correspond to the type of transmission (Stereo or MONO).

To select the MONO function, press frequency selection button 5 (1) until the message "MONO ON" appears on the display. To deactivate the MONO function, press the frequency selection button (2) until the message "MONO OFF" appears on the display.