Manual transmitter tuning and programming

Manual transmitter tuning and programming

Select the frequency range by pressing the BAND (1) button repeatedly. The message on the display will depend on the band selected "FM1", "FM2", "FM3", "MW" or "LW".

Having selected the band, press one of the "▲" "▼" buttons (2,3) for about 6 seconds until the message "MAN" and the frequency tuned into appears on the display. Using the "▲" "▼" buttons it is now possible to alter the tuning frequency in 50 Hz steps for FM ranges and 1kHz for AM frequencies.

The station being listened to can be programmed in the frequency range selected using the frequency selection buttons. At the end of the programming, press the selection button for the frequency until the sound can be heard once again.

The manual tuning can be ended at any time by pressing one of the frequency selection buttons or if none of the buttons has been pressed for 60 seconds.

Listening to programmed stations

Select the desired band using the BN button (1). Press one of the frequency selection buttons briefly.

The display will show the button pressed and the transmitter code if it is an RDS transmitter.

If the transmitter selected offers an RDS service and the reception is not good, the radio will search for an alternative frequency. During the search for the alternative frequency the display will show "SRC".

TP function (Traffic Program)

Several stations on RDS1, RDS2 bands also broadcast traffic news.

With the TP function (Traffic Program) it is possible to:

• a) carry out the search for RDS stations only transmitting traffic news;
• b) receive traffic news even if the cassette player is working;
• c) receive traffic news at a pre-set minimum volume even with the radio volume control at zero.

NOTE Below are the instructions for carrying out each of the operations illustrated in points a), b) and c) previously.