ENGINE OIL COOLING RADIATOR - R + R

Operation 1084C34 · ENGINE OIL COOLING CIRCUIT

2.4 JTD 20v

Removing

- Position the vehicle on a lift.

- Make sure that the ignition key is in the OFF position, then disconnect the battery terminal (-).

Op. 7040D30 ENGINE BAY FRONT BEAM COVER - R R

Op. 7055A43 CENTRE FRONT GRILLE - R.R.

Op. 7055B90 LEFT FRONT WHEEL ARCH LINER - R.R.

Op. 7055B91 RIGHT FRONT WHEEL ARCH LINER - R.R.

Op. 7210E10 R.R. FRONT BUMPER

Op. 1084C40 AIR DUCT FOR ENGINE OIL COOLING RADIATOR - R.R.

1. Unscrew the bolts (1a) and disconnect the engine oil supply and return pipes to the cooling radiator (1b), radiator side.

Collect the engine oil that comes out in a suitable container.

1. Undo the nuts (1a) and remove the engine oil cooling radiator (1b).

Refitting

- Fit the engine oil cooling radiator in place and secure it using the nuts.

- Connect the engine oil supply and return pipes to the coolant radiator, radiator side, and tighten the bolts to the recommended torque.

Replace the O ring seals on the connectors for the engine oil supply and return pipes to the cooling radiator.

Op. 1084C40 AIR DUCT FOR ENGINE OIL COOLING RADIATOR - R.R.

Op. 7210E10 R.R. FRONT BUMPER

Op. 7055B91 RIGHT FRONT WHEEL ARCH LINER - R.R.

Op. 7055B90 LEFT FRONT WHEEL ARCH LINER - R.R.

Op. 7055A43 CENTRE FRONT GRILLE - R.R.

Op. 7040D30 ENGINE BAY FRONT BEAM COVER - R R

- Connect the negative battery terminal.

Op. 0010T11 ENGINE OIL - CHECK LEVEL AND TOP UP, IF NECESSARY

- Remove the vehicle from the lift.