ENGINE OIL PRESSURE WARNING LIGHT SWITCH - R + R

Operation 1084A42 · INDICATORS/CHECK DEVICES

2.2

Removing

- Position the vehicle on a lift.

- Make sure that the ignition key is in the OFF position, then disconnect the battery terminal (-).

Op. 5520B10 STARTER MOTOR - R+R

1. Disconnect the electrical connection from the engine oil pressure warning light switch.

2. Undo and remove the engine oil pressure warning light switch.

Collect the engine oil that comes out in a suitable container.

Refitting

- Replace the engine oil pressure warning light switch in its housing and tighten it to the recommended torque.

- Connect the electrical connection to the engine oil pressure warning light switch.

Op. 5520B10 STARTER MOTOR - R+R

- Connect the negative battery terminal.

- Remove the vehicle from the lift.

1.9 JTD 8v, 1.9 JTD 16v

Removing

- Position the vehicle on a lift.

- Make sure that the ignition key is in the OFF position, then disconnect the battery terminal (-).

Op. 7055B54 UNDER ENGINE PROTECTION/GUARD - R.R.

1. Disconnect the electrical connection from the engine oil pressure warning light switch.

2. Undo and remove the engine oil pressure warning light switch.

Refitting

- Replace the engine oil pressure warning light switch in its housing and tighten it to the recommended torque.

- Connect the electrical connection to the engine oil pressure warning light switch.

Op. 7055B54 UNDER ENGINE PROTECTION/GUARD - R.R.

- Connect the negative battery terminal.

- Remove the vehicle from the lift.

2.4 JTD 20v

Removing

- Position the vehicle on a lift.

- Make sure that the ignition key is in the OFF position, then disconnect the battery terminal (-).

Op. 7055B54 UNDER ENGINE PROTECTION/GUARD - R.R.

1. Disconnect the electrical connection from the engine oil pressure warning light switch.

2. Undo and remove the engine oil pressure warning light switch.

Refitting

- Replace the engine oil pressure warning light switch in its housing and tighten it to the recommended torque.

- Connect the electrical connection to the engine oil pressure warning light switch.

Op. 7055B54 UNDER ENGINE PROTECTION/GUARD - R.R.

- Connect the negative battery terminal.

- Remove the vehicle from the lift.

1.8

Removing

Op. 7055B54 UNDER ENGINE PROTECTION/GUARD - R.R.

Op. 7055B66 ENGINE COMPARTMENT DUST COVER IN RIGHT FRONT WHEEL ARCH - R.R.

Op. 1092G10 SINGLE ENGINE BELT - R.R

- Undo the fastenings and move the air conditioning compressor to one side without disconnecting the pipes. Refer to

Op. 5040A20 AIR CONDITIONING COMPRESSOR - R+R - INCLUDES FLUID LEVEL CHECK AND TOP UP IF NECESSARY

- Retract the protective casing for the engine oil pressure switch connector.

1. Connect the electrical connection for the engine oil pressure switch.

2. Undo and remove the engine oil pressure switch.

Refitting

- Place the engine oil pressure switch in position and tighten it to the recommended torque.

- Connect the electrical connection for the engine oil pressure switch.

- Place the protective casing for the engine oil pressure switch connector in position.

- Place the air conditioning compressor in its housing and tighten it it using the fastenings. Refer to

Op. 5040A20 AIR CONDITIONING COMPRESSOR - R+R - INCLUDES FLUID LEVEL CHECK AND TOP UP IF NECESSARY

Op. 1092G10 SINGLE ENGINE BELT - R.R

Op. 7055B66 ENGINE COMPARTMENT DUST COVER IN RIGHT FRONT WHEEL ARCH - R.R.

Op. 7055B54 UNDER ENGINE PROTECTION/GUARD - R.R.