ENGINE OIL DELIVERY PIPE TO TURBOCHARGER - R + R

Operation 1084B40 · ENGINE OIL LUBRICATION CIRCUIT

1.9 JTD 8v, 1.9 JTD 16v

Removing

- Position the vehicle on a lift.

Op. 1016A10 SOUND-PROOFING COVER - R.R

Op. 5530B10 BATTERY - R+R

Op. 5530B52 BATTERY SUPPORT/DRIP TRAY - R.R

Op. 1048B19 TURBOCHARGER AIR OUTLET HOSE -R.R.

Op. 1048A42 SLEEVE FROM FLOW METER TO TURBO CHARGER AIR INLET PIPE - R + R

Op. 7055B54 UNDER ENGINE PROTECTION/GUARD - R.R.

Op. 1048A50 TURBOCHARGER AIR INTAKE PIPE - R.R.

Op. 1048A10 AIR FILTER ASSEMBLY - R.R.

Op. 1084A16 OIL DIPSTICK PIPE - R.R

Op. 1088D24 WATER PUMP RIGID COOLANT INLET PIPE - R.R.

Op. 1072C44 EXHAUST MANIFOLD HEAT SHIELD - R+R

Op. 1076B72 INTERMEDIATE EXHAUST PIPE WITH HOSE SECTION - R+R

Op. 1080B62 CATALYTIC CONVERTER - R + R

1. Undo the connector (1a) and disconnect the turbocharger engine oil supply pipe (1b), turbocharger side.

1. Undo the connector (1a) and disconnect the turbocharger engine oil supply pipe (1b), engine crankcase side and remove it.

Refitting

1. Place the turbocharger engine oil supply pipe (1a) in position, connect it to the engine crankcase and tighten the connector (1b) to the recommended torque.

1. Connect the turbocharger engine oil supply pipe (1a), turbocharger side and tighten the connector (1b) to the recommended torque.

Op. 1080B62 CATALYTIC CONVERTER - R + R

Op. 1076B72 INTERMEDIATE EXHAUST PIPE WITH HOSE SECTION - R+R

Op. 1072C44 EXHAUST MANIFOLD HEAT SHIELD - R+R

Op. 1088D24 WATER PUMP RIGID COOLANT INLET PIPE - R.R.

Op. 1084A16 OIL DIPSTICK PIPE - R.R

Op. 1048A10 AIR FILTER ASSEMBLY - R.R.

Op. 1048A50 TURBOCHARGER AIR INTAKE PIPE - R.R.

Op. 7055B54 UNDER ENGINE PROTECTION/GUARD - R.R.

Op. 1048A42 SLEEVE FROM FLOW METER TO TURBO CHARGER AIR INLET PIPE - R + R

Op. 1048B19 TURBOCHARGER AIR OUTLET HOSE -R.R.

Op. 5530B52 BATTERY SUPPORT/DRIP TRAY - R.R

Op. 5530B10 BATTERY - R+R

Op. 0010T20 ENGINE COOLANT - CHANGE

Op. 1016A10 SOUND-PROOFING COVER - R.R

- Remove the vehicle from the lift.

2.4 JTD 20v

- On this car it is not possible to remove/refit the engine oil supply pipe to the turbocharger on the car.

To perform this operation, remove/refit the power unit

Op. 1004B14 POWER UNIT WITH AUTOMATIC TRANSMISSION R + R

and then work at the bench, customising the engine service procedures for this operation.