R.R. FRONT BUMPER

Operation 7210E10 · EXTERNAL PARTS

Removing

- Turn the ignition key to the OFF position.

- Open the bonnet.

- Disconnect the negative battery terminal.

Op. 7040D30 ENGINE BAY FRONT BEAM COVER - R R

Op. 7055A43 CENTRE FRONT GRILLE - R.R.

Op. 7055B90 LEFT FRONT WHEEL ARCH LINER - R.R.

Op. 7055B91 RIGHT FRONT WHEEL ARCH LINER - R.R.

1. Using the special tool, release the four retaining buttons for the front part of the protection under the engine on the bodyshell.

2. Undo the four bolts (2a) securing the front protection under the engine (2b) to the bumper trim.

- Remove the front protection under the engine from the vehicle.

1. Disconnect the electrical connections from the fog lights.

1. Undo the upper 5 bolts fixing the bumper.

1. Working on both sides, undo the two bolts fixing the bumper.

2. Remove the bumper from the vehicle.

Refitting

- Check that the bumper is not damaged.

- Place the bumper in position attaching the centering pins and tighten the upper fixing bolts.

- Working on both sides, tighten the two bolts fixing the bumper.

- Connect the electrical connections to the fog lights.

- Check that the front protection under the engine is not damaged.

- Position the front protection and fit the four retaining buttons.

- Tighten the bolts fixing the front protection to the bumper trim.

Op. 7055B91 RIGHT FRONT WHEEL ARCH LINER - R.R.

Op. 7055B90 LEFT FRONT WHEEL ARCH LINER - R.R.

Op. 7055A43 CENTRE FRONT GRILLE - R.R.

Op. 7040D30 ENGINE BAY FRONT BEAM COVER - R R

- Connect the negative battery terminal once again.