DS ELECTRIC INJECTION CONTROL UNIT - R R

Operation 1060G80 · PRESSURE PUMP ELECTRIC CONTROL

2.3 JTD 16V

Removing

See in Op. 1048A10

- Disconnect the negative battery terminal.

1. Disconnect the electrical connections for the injection control unit.

2. Undo the fixing bolts.

3. Remove the engine management control unit from its housing.

Refitting

- Position the control unit in the housing.

- Connect the electrical connections for the control unit.

- Connect the negative battery terminal.

If the engine management control unit is being replaced, the control unit learning procedure must be carried out at the end of the fitting operation.

See in Op. 1048A10

2.8 JTD 8V

Removing

See in Op. 1048A10

- Disconnect the negative battery terminal.

1. Disconnect the electrical connections for the injection control unit.

2. Undo the fixing bolts.

3. Remove the engine management control unit from its housing.

Refitting

- Position the control unit in the housing.

- Connect the electrical connections for the control unit.

- Connect the negative battery terminal.

If the engine management control unit is being replaced, the control unit learning procedure must be carried out at the end of the fitting operation.

See in Op. 1048A10

2.0 JTD 8V

Removing

See in Op. 1048A10

- Disconnect the negative battery terminal.

1. Disconnect the electrical connections for the injection control unit.

2. Undo the fixing bolts.

3. Remove the engine management control unit from its housing.

Refitting

- Position the control unit in the housing.

- Connect the electrical connections for the control unit.

- Connect the negative battery terminal.

If the engine management control unit is being replaced, the control unit learning procedure must be carried out at the end of the fitting operation.

See in Op. 1048A10