FUEL PRESSURE SENSOR - R R

Operation 1060G28 · PRESSURE PUMP ELECTRIC CONTROL

2.3 JTD 16V

Removing

- Disconnect the negative battery terminal.

1. Disconnect the electrical connection for the fuel pressure sensor.

2. Undo the connector and remove the pressure sensor from the housing in the fuel manifold.

Refitting

- Fit the fuel pressure sensor in the special housing in the fuel manifold and tighten the fixing connector.

- Connect the electrical connection for the fuel pressure sensor.

- Connect the negative battery terminal.

2.8 JTD 8V

Removing

See in Op. 1048B22

See in Op. 1048B14

- Open the retaining springs (1a) and remove the inspection cover (1b).

1. Disconnect the electrical connection for the sensor.

2. Undo the fuel pressure sensor and remove it.

Refitting

- Tighten the fuel pressure sensor on the fuel manifold.

- Connect the electrical connection.

- Place the inspection cover in position and close the retaining springs.

See in Op. 1048B14

See in Op. 1048B22

2.0 JTD 8V

Removing

- Disconnect the negative battery terminal.

- Disconnect the engine oil vapour recovery pipe from the tappet cover.

- Disconnect the electrical connection for the sensor.

1. Undo the pressure sensor from the fuel manifold and remove it.

Refitting

- Fit the pressure sensor on the fuel manifold.

- Connect the electrical connection.

- Connect the engine oil vapour recovery pipe to the tappet cover.

- Connect the negative battery terminal.