Workshop Manuals Factory service & repair Fiat
Fiat Seicento Factory Service Manual (1998-2010)02 · 10 Engine
02 · Engine

Refitting

Make
Fiat
Model
Seicento Factory Service Manual
Year
1998–2010
Section
Engine cooling (899) › Refitting
10 EngineRefitting · page 1 of 2

(Cont. Op. 1088D20)

Name Connector
- Battery A1
  • Unscrew the engine coolant tank plug.
  • Raise the vehicle
  1. Unscrew the engine compartment protection screws.
  2. Remove the engine compartment protection.
View of the engine compartment protection being removed, showing securing screws labeled 1 and a lower sleeve labeled 2.
  1. Take out lower sleeve from the radiator and drain the coolant into a suitable container.
Close-up view of the lower coolant sleeve connection at the radiator.
  • Insert the lower sleeve on the radiator .
  1. Take out the engine water pump inlet sleeve from the pump.
View of the engine water pump inlet sleeve labeled 1.
  • Lower the vehicle.
  1. Unscrew (1a) the engine coolant tank securing screws and take (1a) it from the support.
  2. Take out the coolant sleeve from the tank.
Engine coolant tank with securing screws labeled 1a, and delivery pipe connections labeled 2 and 1b.
  • Take out the delivery pipe from the heater (see Op. 5010A12 water delivery PIPE to heater - R+R) and remove it.

Refitting

  • Reposition and insert the water delivery pipe on the heater (see Op. 5010A12 water delivery PIPE to heater - R+R).

(Cont.)

Parts & tools for this job For 1998 Fiat Seicento

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.