Transfer Box LT230SE High/Low Selector Cable Repair
TRANSFER BOX - LT230SE
REPAIRS
41-35
Cable - high/low selector
$% 41.20.43
Remove
1. Raise vehicle on a ramp.
2. Using a suitable crowsfoot spanner, remove
lock nut and washer securing outer cable to
abutment bracket.
3. Remove clevis pin securing inner cable to
transfer box lever and release cable from
abutment bracket.
4. Release 'C' clip securing outer cable to high/
low lever abutment bracket.
5. Remove clevis pin securing inner cable to high/
low lever.
6. Remove bolt securing outer cable clip to cross
shaft housing, remove cable.
Refit
1. Clean change levers, abutment bracket and
clevis pins.
2. Apply Mobilith SHC 100 grease to inner cable
ends and clevis pins.
3. Position cable and secure to high/low lever
abutment bracket with 'C' clip.
4. Secure inner cable to high/low lever with clevis
pin.
5. Position outer cable clip to cross shaft housing,
tighten bolt to 15 Nm (11 lbf.ft).
6. Adjust high/low selector cable.